Wolf Pro ventilation hoodseries User manual

PRO VENTILATION HOOD

USE AND CARE GUIDE

CLEANING, MAINTENANCE, AND MORE

Wolf Customer Care 800.222.7820

Contents

4Safety Precautions

6Hood Features

7Hood Operation

9Care Recommendations

10 Troubleshooting

11 Wolf Warranty

PRO VENTILATION HOOD

wolfappliance.com

Customer Care

The model and serial number are printed on the enclosed

product registration card. Both numbers are also listed on

the product rating plate. Refer to page 6 for rating plate

location. For warranty purposes, you will also need the date

of installation and name of your authorized Wolf dealer.

Record this information below for future reference.

SERVICE INFORMATION

Model Number

Serial Number

Date of Installation

Certied Service Name

Certied Service Number

Authorized Dealer

Dealer Number

If your product ever needs attention, be sure to use a Wolf

Factory Certied Service provider recommended by our

customer care center, or select one from our list of providers

available at wolfappliance.com/locator. All Factory Certi-

ed Service providers are carefully selected and thoroughly

trained by us.

Important Note

To ensure this product is installed and operated as safely

and efciently as possible, take note of the following types

of highlighted information throughout this guide:

IMPORTANT NOTE highlights information that is especially

important.

CAUTION indicates a situation where minor injury or product

damage may occur if instructions are not followed.

WARNING states a hazard that may cause serious injury or

death if precautions are not followed.

IMPORTANT NOTE: Throughout this guide, dimensions in

parentheses are millimeters unless otherwise specied.

PRO VENTILATION HOOD

Wolf Customer Care 800.222.7820

SAFETY PRECAUTIONS

GENERAL SAFETY PRECAUTIONS

•Sufcient air is needed for proper combustion and

exhausting of gases through the ue (chimney) of

fuel burning equipment to prevent back drafting.

•Follow the heating equipment manufacturer’s

guideline and safety standards such as those pub-

lished by the National Fire Protection Association

(NFPA), the American Society for Heating, Refrig-

eration and Air Conditioning Engineers (ASHRAE)

and the local code authorities.

CAUTION

For general ventilating use only. Do not use to

exhaust hazardous or explosive materials and

vapors.

•Ducted fans must always be vented to the

outdoors.

•To reduce the risk of re, use only steel ductwork.

CAUTION

To reduce the risk of re and properly exhaust air,

be certain to duct air outside. Do not vent exhaust

air into spaces within walls or ceilings or into

attics, crawl spaces or garages.

IMPORTANT INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

•Read this use & care guide carefully before using

your new ventilation hood to reduce the risk of re,

electric shock or injury to persons.

•Ensure proper installation and servicing. This

appliance must be properly installed and grounded

by a qualied technician.

•Warranty service must be performed by Wolf

Factory Certied Service.

•Installation work and electrical wiring must be done

by qualied person(s) in accordance with all appli-

cable codes and standards, including re-rated

construction codes and standards.

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC

SHOCK, OR INJURY TO PERSONS, OBSERVE

THE FOLLOWING:

Use this unit only in the manner intended by

the manufacturer. If you have questions, con-

tact the manufacturer.

b) Before servicing or cleaning unit, unplug the

appliance or switch power off at service panel

and lock the service disconnecting means

to prevent power from being switched on

accidentally. When the service disconnecting

means cannot be locked, securely fasten a

prominent warning device, such as a tag, to

the service panel.

wolfappliance.com

SAFETY PRECAUTIONS

IMPORTANT INSTRUCTIONS

GENERAL SAFETY PRECAUTIONS

•Do not repair or replace any part of this appliance

unless specically recommended in this guide. All

other service should be performed by a qualied

technician.

•To avoid motor bearing damage and noisy or

unbalanced impellers, keep drywall spray, con-

struction dust, etc. off power unit.

•When cutting or drilling into wall or ceiling, do not

damage electrical wiring or other hidden utilities.

•Please read the specication label on the ventila-

tion hood for further information and requirements.

WARNING

TO REDUCE THE RISK OF A RANGE TOP

GREASE FIRE:

Never leave surface units unattended at high

settings. Boilovers cause smoking and greasy

spillovers that may ignite. Heat oils slowly on

low or medium settings.

b) Always turn hood ON when cooking at high

heat or when ambéing food (i.e. Crepes

Suzette, Cherries Jubilee, Peppercorn Beef

Flambé).

c) Clean ventilating fans frequently. Grease should

not be allowed to accumulate on fan or lter.

d) Use proper pan size. Always use cookware

appropriate for the size of the surface element.

WARNING

TO REDUCE THE RISK OF INJURY TO

PERSONS IN THE EVENT OF A RANGE TOP

GREASE FIRE, OBSERVE THE FOLLOWING*:

SMOTHER FLAMES with a close-tting lid,

cookie sheet, or metal tray, then turn off the

burner. BE CAREFUL TO PREVENT BURNS.

If the ames do not go out immediately, EVAC-

UATE AND CALL THE FIRE DEPARTMENT.

b) NEVER PICK UP A FLAMING PAN—You may

be burned.

c) DO NOT USE WATER, including wet dishcloths

or towels—a violent steam explosion will result.

d) Use an extinguisher ONLY if:

1) You know you have a Class ABC extin-

guisher, and you already know how to

operate it.

2) The re is small and contained in the area

where it started.

3) The re department is being called.

4) You can ght the re with your back to an

exit.

*Based on“Kitchen Fire Safety Tips” published by NFPA.

WARNING

PROPOSITION 65 FOR CALIFORNIA RESIDENTS

Cancer and Reproductive Harm—

www.P65Warnings.ca.gov

Wolf Customer Care 800.222.7820

ISLAND HOOD

WALL CHIMNEY HOOD

HOOD LINER

HOOD FEATURES

Pro Ventilation Hood Features

FEATURES

1Product Rating Plate (inside hood shell)

2Recessed Controls

3Filters

4Halogen Lighting

WALL HOOD

W482418 wall hood shown

WC482418 wall chimney hood shown

I5434418 island hood shown

L462212 hood liner shown

wolfappliance.com

Hood Controls

Controls for pro ventilation hoods and hood liners are

recessed under the front edge of the hood. Refer to the

illustration below.

LIGHTS

The control knob on the left operates the halogen lights.

From the OFF position, turn the knob to the left for LOW

and right for the HIGH light setting.

HEAT LAMP

For 27" deep wall hoods, the center control knob operates

the heat lamps. Each lamp can be controlled independently

or simultaneously. Turn the knob to the left, right or center to

select desired setting.

BLOWER

The control knob on the right operates the blower with

innite control of blower speed. To turn the blower off, turn

the knob counterclockwise.

HOOD OPERATION

LIGHTS

HEAT

LAMPS

BLOWER

Hood controls

Heat Sentry

The heat sentry feature automatically turns the blower on

or increases blower speed when the exhaust temperature

exceeds 200°F (95°C). It automatically adjust blower speed

to the previous setting once the temperature drops below

186°F (85°C).

Wolf Customer Care 800.222.7820

HOOD OPERATION

Lighting

LIGHT BULB REPLACEMENT

Pro ventilation hoods require 50W, 120V, GU10 halogen

light bulbs, available through an authorized Wolf dealer. For

local dealer information, visit the nd a showroom section of

our website, wolfappliance.com.

A suction-cup-style light bulb changer is provided with

the ventilation hood. To remove a bulb, use the changer to

rotate the bulb counterclockwise one-quarter turn. Refer to

the illustration below.

Heat Lamps

For 27" deep wall hoods, two heat lamp receptacles require

R40, 250W bulbs (not included). Bulbs are available at hard-

ware stores or through an authorized Wolf dealer. For local

dealer information, visit the nd a showroom section of our

website, wolfappliance.com.

Allow the heat lamps to cool before replacing bulbs.

Unscrew the bulb to replace.

CAUTION

Use caution when replacing heat lamp bulbs. Adjacent

parts of the ventilation hood may retain heat.

LIGHT BULB

CHANGER

Light bulb replacement

wolfappliance.com

CARE RECOMMENDATIONS

Filter Removal

The lters are dishwasher safe. Refer to care

recommendations.

Remove the center lter rst. To remove, press lter upward

then rotate the bottom downward. Refer to the illustration

below. Remove grease cups from the bottom edge of the

hood (not included with low-prole wall hoods and hood

liners). Gloves should be worn when handling lters.

Reinstall using the reverse procedure. Slide outer lters over

slightly to reinstall the center lter.

IMPORTANT NOTE: Do not operate the ventilation hood

without lters. This may damage the blower or other internal

components of the hood.

Care Recommendations

CLEANING

Stainless

steel

Use a nonabrasive stainless steel cleaner and

apply with a soft lint-free cloth. To bring out the

natural luster, lightly wipe surface with a water-

dampened microber cloth followed by a dry

polishing chamois. Always follow the grain of

stainless steel.

Control

knobs

Using a damp cloth, wipe with mild detergent or

spray degreaser. Rinse and dry.

IMPORTANT NOTE: Do not spray cleaners

directly on the control knobs.

Filters

Grease cups

Filters are dishwasher safe and are designed to

t most dishwashers. Wipe lters and grease

cups (if applicable) to remove excess grease

before placing in the dishwasher.

FILTER

SIDE VIEW

SPRING GREASE

CUP

Filter removal

Wolf Customer Care 800.222.7820

SERVICE

•Maintain the quality built into your product by contacting

Wolf Factory Certied Service. For the name of the

nearest Wolf Factory Certied Service, check the contact

& support section of our website, wolfappliance.com or

call Wolf customer care at 800-222-7820.

•When contacting service, you will need the model and

serial number of your product. Both numbers are listed

on the product rating plate, located inside the left wall of

the hood shell. Refer to page 6 for rating plate location.

•For warranty purposes, you will also need the date of

installation and name of your authorized Wolf dealer. This

information should be recorded on page 3 of this guide.

TROUBLESHOOTING

Troubleshooting

OPERATION

Ventilation hood does not operate.

•Verify power is on.

•Verify electrical power to hood and home circuit breaker

is on.

Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &

Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.