Workrite Ergonomics Sierra Privacy Panel User manual

WorkRite Ergonomics | 800.959.9675 www.workriteergo.com
#1500128 - Rev A
E
5
/
32
" Allen Wrench
Qty: 1
DWashers Qty: 2CSet screws Qty: 2
ASierra Tool Bar or Privacy Panel Qty: 1 BStanchion
Qty: 2
Parts by Carton
Assembly Instructions
for Sierra Tool Bar and
Sierra Privacy Panel
Attach Tool Bar or Privacy Panel to Stanchions
Align Tool Bar with holes in Stanchion. Notice that the sections of the Tool Bar are not symmetri-
cal and position the Tool Bar with the short section on the top.
Push Tool Bar into holes in Stanchion. Be sure it is pushed all the way in.
Repeat for the other Stanchion.
1
A
a
b
ab
B
Verify that you have all the hardware needed for the assembly.
OR
If you have purchased the SwingArm Sierra Tool
Bar mount (SAPAN01), mount it to the Tool Bar
BEFORE attaching Tool Bar to Stanchions.
Note: Shortest
bar on top
Two persons might be required to install longest
versions of Tool Bar/Privacy Panel.

2 WorkRite Ergonomics | 800.959.9675 www.workriteergo.com
Assembly Instructions for Sierra Tool Bar and Privacy Panel #1500128 - Rev A
2
3
Attach Tool Bar to Worksurface
Thread Set Screws into bottom of Stanchions until screw is visible. Slide Tool Bar onto back of
worksurface. For two-leg tables, Tool Bars are designed to t so that Stanchions align with center
of table legs. For three-leg tables, Tool Bars are designed to t so that outside Stanchion aligns
with center of outside table leg.
Place one washer between the bottom of the worksurface and the Stanchion, resting it on the top
of the Set Screw. Tighten the Set Screw with the M5 Allen wrench provided. Repeat on other side.
D
Attach Accessories
Attach Sierra Accessories to Tool Bar with the hook facing downward.
Insert the hook into the groove of the Tool Bar and then push down.
a
b
ab
E
C
3500127: Stanchion cap, Sierra Silver
3500128: Stanchion cap, Charcoal
4200109: Sierra Tool Bar Hardware kit
Replacement Part Numbers
Align center of table leg
to center of stanchion.