World Market 543575 User manual

SHELF BRACKET ARCHED BLACK LARGE
SKU - 543575
THANK YOU FOR YOUR PURCHASE. IF YOU HAVE ANY QUESTION PERTAINING
TO ASSEMBLY OF THIS PRODUCT, PLEASE CONTACT THE
NEAREST COST PLUS WORLD MARKET STORE. IF YOU ARE NOT NEAR A STORE,
PLEASE CALL OUR CUSTOMER SERVICE CALL CENTER
TOLL FREE AT 877-967-5362 FOR ASSISTACE.

Parts List
Picture Description Qty Label
A
Page 2
Tool List
Hardware List
H-1
H-2
T-2
T-1
H-3
T-3
2
4
4
1
4
Allen Bolt
(L 17mm x 6mm)
Screws
(L 32mm x 4mm)
Wall Plugs
(L 42mm x 10mm)
Bracket
(Drill Bit -10mm)
Allen Key
Screw Driver

Turn the shelf in upright position. Locate the stud on the wall. With the help of two people, align assembled shelf on the
wall and mark the location of the hole. Use water leveler to ensure that shelf is in level. Pre-drill holes at marked
location.
Place shelf on a non-marring padded surface. Align bracket (A) end with oval holes over shelf as shown above in
the image. Insert allen bolt (H-3) in the holes and secure with allen key (T-1). Repeat the process to secure other
bracket (A).
Step-1
Assembly Steps
Page 3
A
H-3
H-3
H-3
T-1
H-3 A
Leveler
A
A
A
T-2
Wall
T2
not included

Assembly Steps
Step-2
Assembled view
Page 4
Note - Bracket set is meant to be used with World Market shelves sold separately.
Maximum Load - 28 lbs
Insert wall plug (H-1) if you are mounting on a dry wall. Insert screw (H-2) into wall plug (H-1) as shown above in the drawing.
Leave 1/4" of the screw (H-2) out of the wall as shown above in drawing. Align keyhole over screw (H-2) and pull down shelf
until secured. Insert screws (H-2) at lower ends and fully tighten connections with screw driver (T-3).