World Tech Toys 33805 User manual

DART BLASTER OVERVIEW:
INSTRUCTION MANUAL
8+
ITEM NO. 33805
CROSSBOW
4 FIRING DART CHAMBERS
FIXED STOCK
PULL BACK SLIDE
BATTERY COMPARTMENT
SIGHT

BATTERY INSTALLATION (OPTIONAL)
DART BLASTER ASSEMBLY
To assemble dart blaster, insert bow pieces into main body of
blaster by pushing down on release slide (1.) and lining up tabs
with body as you push pieces in until secure (2.) for both sides.
Thread bow string through one side of bow as shown (3.) and
thread through both parts of blasters pull slide (4.) and tie off
on opposite end (5.). Tie knots on both ends to prevent bow
string from coming loose and snapping back during operation.
This Blaster has optional light up effects that activate whenever
the trigger is pulled, this requires 3 x AG13/LR44 button cell
batteries.
Remove battery cover using a screwdriver and install batteries
making sure the polarity is correct. Replace battery cover and
secure with screw.
Note the polarity (+ and - marks on batteries) and install with all
batteries facing the correct direction.
LR44
AG13
+
LR44
AG13
+
LR44
AG13
+
2.
3.
4.
5.
1.

OPERATING DART BLASTER
DISSASEMBLING DART BLASTER
LOADING DART BLASTER
Pull back the slide all the way to
ready the dart blaster.
Untie bow string on both sides of
bow and remove from dart blaster.
To remove bow pieces push down
on release slide as shown and pull
straight out of slot for both sides.
Pull the trigger to fire the loaded
blaster dart. Pull back slide again
to ready next dart.
Load 4 darts into the blaster as shown. To avoid damage to
darts and/or blaster, do not force dart all the way in. About 1/4
of dart should stick out of barrel. Each chamber will fire in
succession from top to bottom.

TROUBLESHOOTING DART BLASTER
Website: www.worldtechtoys.com
Email: [email protected]
Phone: [phone]
Monday - Friday / 9:00AM - 5:00PM / Pacific Time
WWW.WORLDTECHTOYS.COM
PROBLEM CAUSE SOLUTION
Blaster does not fire.
Blaster trigger not working.
Darts are firing inconsistently.
Blaster has obstruction.
Darts are damaged. Replace the damaged darts.
Blasters pull back slide was not
completely pulled back.
Pull back on slide until a click is
heard.
Blasters pull back slide was not
completely pulled back.
Pull back on slide until a click is
heard.
Blaster has obstruction.
Remove darts from barrels and
remove any obstructions.
Blaster barrel is empty. Load blaster with darts.
Remove darts from barrels and
remove any obstructions.