World Tech Toys 35922 User manual

2.4GHz 3.5CH REMOTE CONTROL HELICOPTER
ITEM NO. 35922
FOR AGES 8 AND UP
8+

• World’s Only Unbreakable Helicopter
• Super Strong Polymer Body
• Helicopter Body Can Take Up To 200 Pounds Of Force
• Full Size Joystick Transmitter
• 2.4GHz Radio Technology
• 3.5 Channel Radio Control
• Built In Gyro
• LED Lights
• Turbo Button
• Sound FX And Vibration
• USB CHARGER
FEATURES
• Body Length: 15.5 Inches
• Body Width: 2.75 Inches
• Body Height: 7.75 Inches
• Main Rotor Diameter: 13 Inches
• Weight: 0.5 Pounds
• Flight Time: Approx. 10 Minutes
• Charging Time: 15-30 Minutes
SPECIFICATIONS
INTRODUCTION
HELICOPTER
Thank you for purchasing this World Tech Toys product. Please make sure you
carefully read the entire manual before operating this RC helicopter. This
helicopter is recommended for ages 8 and up.
COAXIAL ROTOR
STABILIZER
CONNECTING SHAFT
LANDING SKIDS
SUPER STRONG
POLYMER FRAME
LED LIGHT
DURABLE
PLASTIC BODY
TAIL
ROTOR

TRANSMITTER
BATTERY INSTALLATION
• Remove the battery cover and install 4 AA Batteries as shown.
• Replace the battery cover.
• Please note polarity and orientation of batteries.
MACHINE GUN
SOUND FX
LEFT TURN/RIGHT TURN/
FORWARD/BACKWARD
JOYSTICK
LIGHT BUTTON
DEMO MODE
VOLUME BUTTON
POWER
BUTTON
USB CHARGING
PORT
1: SILENT MODE
2: SOUND FX ON
3: MUSIC MODE
TURBO
BUTTON
RIGHT
TRIM
LEFT
TRIM
THROTTLE
BOTTOM OF JOYSTICK
TRANSMITTER

CHARGING THE HELICOPTER
WARNING:
• Do not charge the helicopter battery unsupervised.
• Do not overcharge the helicopter battery. Overcharging the battery will
damage the battery causing it to not hold as long as a charge.
• Only charge the helicopter battery with the included wall charger.
The Nano Hercules Helipilot comes with a USB Charger to charge the helicopter. You can use
the USB charge port on the Joystick transmitter or use a USB port on a computer or USB wall
charger that you already own to charge the helicopter.
1. Make sure both the Joystick Transmitter and the Helicopter’s power is OFF.
2. Open the USB Charging Port on the Joystick Transmitter.
3. Plug the USB Charger into the bottom of the Helicopter and the USB Charging Port on the
Transmitter.
4. The RED light on the USB Charger will turn on when the helicopter is done charging. Full
charge will take approximately 30 - 45 minutes.
5. Once the Helicopter is charged, remove the USB Charger from the Joystick Transmitter and
the Helicopter.
The Joystick Transmitter’s power does not need to be ON to charge the Helicopter.
FULL CHARGE WILL TAKE APPROXIMATELY 30 - 45 MINUTES
CHARGING OFF THE JOYSTICK TRANSMITTER:
1. Make sure the Helicopter’s power is OFF.
2. Plug the USB Charger into the bottom of the Helicopter and the USB Port.
3. The RED light on the USB Charger will turn on when the helicopter is done charging. Full
charge will take approximately 30 - 45 minutes.
4. Once the Helicopter is charged, remove the USB Charger from the USB Port and the
Helicopter.
CHARGING OFF USB PORT (Computer / Wall Charger):

1: Parental Guidance is suggested for children operating Helicopter.
2: Multiple Helicopters operating simultaneously must be on different Frequency Bands.
• Be sure that Helicopter Battery is fully charged and Remote Control Batteries are fresh.
• Helicopter will fly best in low wind conditions.
• Fly Helicopter in a wide open area with no people, pets, and other objects in the way.
•
Do not fly in strong winds. This will make operation difficult and crash the Helicopter.
FLY UP FLY DOWN
TAKING OFF
FLIGHT CONTROLS
PREFLIGHT CONDITIONS
1. Turn on the Helicopter and place it on a flat surface.
2. Make sure throttle is pushed all the way back before turning on the joystick.
3. Turn on the joystick and push the throttle all the way forward then all the way back to
sync the joystick to the helicopter. The power indicator light should stop flashing when
they are synced.
4. Check surroundings to be sure that it is clear of people, animals, and obstructions.
5. Slowly push the Throttle Stick up to increase blade speed for lift.
6. Adjust throttle input to maintain a steady hover.
The joystick and throttle will move the helicopter as follows:

HELICOPTER SPINS LEFT HELICOPTER SPINS RIGHT
FORWARD BACKWARD
FLIGHT CONTROLS CONTINUED
ADJUSTING THE TRIM
If the helicopter spins to the left or right when hovering without your input, you will
need to adjust the trim.
Click the Right Trim button until
the helicopter stops spinning.
Click the Left Trim button until
the helicopter stops spinning.
TURN LEFT TURN RIGHT
RIGHT
TRIM
LEFT
TRIM

DEMO MODE
TURBO MODE
TROUBLESHOOTING
The Transmitter
indicator LED
does not work
Helicopter does
not take off.
Helicopter is not synced to the transmitter. Go through the proper take off procedures to sync the helicopter
to the transmitter.
No control
of the helicopter
Helicopter is
not flying high
enough
Batteries installed with the wrong polarity.
Move closer to the helicopter.
Fly the helicopter in an area with less radio interference.
Helicopter is not receiving signal from
transmitter.
Test the control functions of the helicopter in a
hover by applying light throttle and testing left and
right controls.
Helicopter is not receiving signal from
transmitter correctly.
Push the throttle forward for more rotor speed.Rotor speed is too slow.
Fully charge helicopter before use.Batteries are drained.
Fly helicopter in calm conditions.Windy Conditions.
Check the polarity of the batteries and install them
Correctly.
Batteries are drained. Install new batteries.
Clicking the Turbo button will put the helicopter in TURBO MODE.
The helicopter will now fly forward and backward faster. Press the
Turbo button again to turn off TURBO MODE.
Pressing this button will put the helicopter in
DEMO MODE. The helicopter will
automatically perform air maneuvers without
your input. Press the button again to turn off
DEMO MODE.
DEMO MODE
TURBO
BUTTON

Website: www.worldtechtoys.com
Email: [email protected]
Phone: [phone]
Monday - Friday / 9:00AM - 5:00PM / Pacific Time
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in a accordance with the instructions,
may cause harmful interference with radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC Label Compliance Statement:
WWW.WORLDTECHTOYS.COM
MADE IN CHINA
SPECIFICATIONS, COLORS AND CONTENT
MAY VARY FROM ILLUSTRATIONS
WARNING:
1. Do not disassemble the RC helicopter or transmitter.
2. Do not operate the helicopter with the same frequency with other RCs in the same location.
The same frequency RC will cause interference and you will lose control of the helicopter.
3. Make sure the batteries are installed with the correct polarity (+/-) as shown inside the battery
compartment.
1. Alkaline batteries are recommended to use in the transmitter.
2. Only batteries of the same or equivalent type as recommended are to be used.
3. Do not mix alkaline, standard or rechargeable batteries.
4. Do not mix old and new batteries or different types of batteries.
5. Do not recharge non rechargeable batteries.
6. If rechargeable batteries are used, only charge them under adult supervision.
7. Rechargeable batteries are to be removed from the helicopter before they are charged.
8. Be sure to insert the batteries with the correct polarities and always follow the battery
manufacturer’s instructions.
9. Remove all batteries from the helicopter and transmitter when not in use.
10.Remove exhausted batteries from the product.
11.Do no short circuit the supply terminals.
12.Dispose of batteries properly. Do not dispose of batteries in fire - it may cause the battery to
explode or leak causing injury or damage.
13.Battery change must be only made by adults.
BATTERY TIPS: