Worx WX026 Installation manual

SAFETY AND OPERATING MANUAL
ORIGINAL INSTRUCTIONS
LED Worklight WX026 WX026.9

1
2
3
5
4
6
7
8
9

AB
CD
EF
GH
1
2

AB
CD
EF
GH
1
2

LED Worklight EN
6
1. HANDLE SLEEVE
2. HANDLE
3. ADJUSTING KNOB
4. HOOK
5. BRACKET SEAT
6. RUBBER PAD
7. BRACKET
8. FRONT COVER
9. ON / OFF SWITCH
* Not all the accessories illustrated or described are included in standard delivery.
TECHNICAL DATA
Type WX026 WX026.9(0- designation of machinery, representative of Lamp)
WX026 WX026.9
Rated voltage 20V Max**
Charger voltage 100-240V ~ 50/60Hz
Working time 2h 1.5h,2h,4h
Lumen 1500LM
Machine weight 1.8kg
**Voltage measured without workload. Initial battery voltage reaches maximum of 20 volts.
Nominal voltage is 18 volts.
ACCESSORIES
WX026 WX026.9
Battery Pack (2.0Ah WA3551.1) 1 /
Charger(0.4A WA3760) 1 /

LED Worklight EN
7
SAFETY POINTS FOR YOUR
FLASHLIGHT/ WORKLIGHT
SAFETY RULES FOR
CORDLESS PORTABLE
HAND-HELD LIGHT
CHARGE BATTERY BEFORE
FIRST USE
CAUTION: Read, understand
and follow all Safety Rules and
Operating Instructions in this Manual
before using this product.
SAVE THESE
INSTRUCTIONS!
READ ALL INSTRUCTIONS!
SAFETY INSTRUCTIONS
WARNING: Be sure to read and
understand all instructions in
this manual before using this portable
hand-held light. Failure to follow all
instructions may result in electric
shock, fire and/or serious personal
injury.
1. Know your cordless portable hand-
held light. Read operator’s manual
carefully.
Learn its applications and limitations,
as well as the specific potential hazards
related to this light.
2. Use only recommended battery pack
and charging stand / transformer.
Any attempt to use another battery pack
will cause damage to the portable hand-
held light and could possible explode,
cause a fire, or personal injury.
Model Battery Pack Charging Stand/
Transformer
WX026 2.0Ah
WA3551.1 0.4A WA3760
WX026.9 / /
* Models of charger and battery pack listed
above are for reference only, you can also
choose other models adapted to the work
light produced by our company. Store
personnel can assist you and offer detail
advice.
3. Remove battery pack from portable
hand-held light before replacing
bulb or performing any routine
maintenance or cleaning.
4. Let portable hand-held light cool for
several minutes after use before changing
the bulb.
5. Do not disassemble the portable hand-
held light.
6. Do not place portable hand-held light or
battery pack near fire or heat.They may
explode. Also, do not dispose of a worn
out battery pack by incineration, even if it
is severely damaged or completely worn
out.The battery may explode in fire.
7. Do not operate portable hand-held
light or charging stand/transformer
near flammable liquids or in gaseous
or explosive atmospheres. Internal
sparks may ignite fumes.
8. To reduce the risk of electric shock,
do not put portable hand-held light in
water or other liquid. Do not place or
store portable hand-held light where it can
fall or be pulled into a tub or sink.
9. Do not permit children to
use portable hand-held light
unsupervised. It is not a toy. The
temperature of the bulb will become hot
after being on only a short period of time.
This hot temperature can cause burn
injury if touched.
10.DO NOT USE OR PERMIT USE OF
PORTABLE HAND-HELD LIGHT IN BED
OR SLEEPING BAGS. This portable
hand-held light lens can melt fabric
and a burn injury could result.
11.Keep light dry, clean, and free from
oil and grease. Always use a clean
cloth when cleaning. Never use brake
fluid, gasoline, petroleum-base products
or any strong solvent to clean the portable
hand-held light.

LED Worklight EN
8
SAFETY WARNINGS FOR
BATTERY PACK
a) Do not dismantle, open or shred cells
or battery pack.
b) Do not short-circuit a battery
pack. Do not store battery packs
haphazardly in a box or drawer where
they may short-circuit each other
or be short-circuited by conductive
materials. When battery pack is not
in use, keep it away from other metal
objects, like paper clips, coins, keys, nails,
screws or other small metal objects, that
can make a connection from one terminal
to another. Shorting the battery terminals
together may cause burns or a fire.
c) Do not expose battery pack to
heat or fire. Avoid storage in direct
sunlight.
d) Do not subject battery pack to
mechanical shock.
e) In the event of battery leaking, do not
allow the liquid to come into contact
with the skin or eyes. If contact has
been made, wash the affected area
with copious amounts of water and
seek medical advice.
f) Seek medical advice immediately
if a cell or battery pack has been
swallowed.
g) Keep battery pack clean and dry.
h) Wipe the battery pack terminals with
a clean dry cloth if they become
dirty.
i) Battery pack needs to be charged
before use. Always refer to this
instruction and use the correct
charging procedure.
j) Do not maintain battery pack on
charge when not in use.
k) After extended periods of storage,
it may be necessary to charge
and discharge the battery pack
several times to obtain maximum
performance.
l) Battery pack gives its best performance
when it is operated at normal room
temperature (20°C ± 5°C).
m)When disposing of battery packs,
keep battery packs of different
electrochemical systems separate
from each other.
n) Recharge only with the charger
specified by WORX. Do not use any
charger other than that specifically
provided for use with the equipment. A
charger that is suitable for one type of
battery pack may create a risk of fire when
used with another battery pack.
o) Do not use any battery pack which
is not designed for use with the
equipment.
p) Keep battery pack out of the reach of
children.
q) Retain the original product literature
for future reference.
r) Remove the battery from the
equipment when not in use.
s) Dispose of properly.

LED Worklight EN
9
SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Do not expose to rain or water
Do not burn
Class III
Do not stare at the operating light
source
Li-Ion battery This product has
been marked with a symbol
relating to ‘separate collection’
for all battery packs and battery
pack. It will then be recycled or
dismantled in order to reduce
the impact on the environment.
Battery packs can be hazardous
for the environment and for
human health since they contain
hazardous substances.
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your
local authorities or retailer for
recycling advice.
xINR18/65-y: Cylindrical lithium
Ion battery cells with max
diameter of 18mm and max
height of 65mm; “x” represents
a number cells serial connected,
blank if 1; “-y” represents a
number of cells paralleled
connected, blank if 1.

LED Worklight EN
10
OPERATING INSTRUCTIONS
OPERATION
ACTION FIGURE
BEFORE OPERATION
Charging the battery Pack See Fig. A
Installing the battery pack See Fig. B
Removing the battery pack See Fig. C
OPERATION
Starting & Stopping
To start your light just depress on/off switch(1) marked “I”.
To stop your light just depress the on/off switch(1) marked “O”.
WARNING! Do not direct the light beam into your eyes.
See Fig. D
Placing the light
WARNING! Ensure the work light is securely placed to prevent
falling object hazard.
Using the hook to hang the light
WARNING! Do not hang the work light on any electrical power cord! See Fig. E
Using the bracket to set the light
Add: You may use a screw to secure the work light in place. See Fig. F
Using the bracket to hang the light See Fig. G
Adjustable head
The work light head can be set in a variety of positions.To switch base
positions, rotate the adjusting knob to loosen the light. Adjust head to desired
position , tighten the adjusting knob.
CAUTION! Do not place hands or fingers between adjustable head and
bracket when positioning work light to avoid any hazard!
See Fig. H
MAINTENANCE AND SERVICING
We recommend that you purchase your accessories listed in the above list from the same store
that sold you the tool. Refer to the accessory packaging for further details. Store personnel can
assist you and offer advice.

LED Worklight EN
11
DECLARATION OF
CONFORMITY
We,
Positec PowerTools (Europe) Ltd,
PO Box 6242, Newbury, RG14 9LT, UK
Declare that the product
Description: Battery-operated lamp
Type: WX026 WX026.9(0- designation of
machinery, representative of Lamp)
Function: Lighting
Complies with the following Directives:
2011/65/EU, 2014/30/EU
Standards conform to
EN 55015
EN 61547
EN 60598-1
EN 60598-2-4
EN 62493
The person authorized to compile the technical
file,
Name: Russell Nicholson
Address: Positec Power Tools (Europe)
Ltd, PO Box 6242, Newbury, RG14 9LT,
UK
Suzhou 2016/04/28
Allen Ding
Deputy Chief Engineer,Testing & Certification

Copyright © 2016, Positec. All Rights Reserved.
AR01240800
www.worx.com
Handle With Care. Do Not Load or
Transport Package If Damaged.
A Fire Hazard Could Exist.
For more information, call: [phone]
LITHIUM ION BATTERY