WUBEN A9 User manual

A9
USER MANUAL

2
Dear customer, thank you for purchasing our product. Please read the following
instructions carefully and follow them to ensure that the product serves you safely and
to your full satisfaction. This will prevent it from being misused or damaged. Avoid
unprofessional handling of this device and always follow the principles of use of
electrical appliances. Keep the operating instructions in a safe place.
Warnings
•Please read the user manual carefully before using the product.
•This product generates heat while working, please be cautious to avoid any possible
harm.
•Please don’t shine the product directly into eyes.
•Please keep the light away from children.
•Please use WUBEN or WUBEN recommended batteries.
•Please don’t disassemble the light or it will not be covered by WUBEN warranty
policy.
•Please don't throw the product or battery into fire.
•This is not a product intended for diving, please do not use it underwater.
Package List
Before using this product, please check whether the contents of the package are
complete.
1. A9 × 1
2. ABG10200 Li-ion
battery × 1
3. Shoulder strap × 1
4. Spare O-ring × 2
5. Type-C charging
cable × 1
6. Adapter × 1
7. Manual, warranty card, quality certificate × 1

3
Product Operation
1. About Product
The A9 is a high power flashlight, powered by a customized Li-ion battery pack of
10200mAh, and utilizing 3 × CREE XHP70.2 LEDs. It emits as high as 12000 lumens at
maximum output. The side switch design makes it possible for the user to operate the
device with one hand.
The positive and negative pole are on the same end of the battery,
please make sure that there is no conductive material present to avoid
a short circuit.
2. Installation
Please remove the insulation plate before using.

4
3. Operation
A. Outdoor Mode
1. ON/OFF: Press the switch to turn on the flashlight, press again to turn it off. This
flashlight has a memory function, allowing it to memorize the output levels instead of
flash modes.
2. Default Output Selection: When the light is on, press and hold the switch to cycle
through Low-Med-High-Turbo, release to select your desired power level.
3. Continuous Output Selection: When the light is off, press and hold the switch to
activate the Low output level, and do not release to go from 100 lumens to 12000
lumens and then from 12000 lumens to 100 lumens back and forth, release to select an
output in between. Click once to turn the device once, and click again to turn the device
on. The device will now have the output level that you last selected between 100 and
12000 lumens.
4. Instant Turbo: When the light is on and not on Turbo mode, press the switch twice
to activate Turbo. Release to turn it off.
5. Flash Mode: When the light is off or on Turbo, click on the switch twice to activate
Strobe, and click twice again to swap between Strobe and SOS. Press again to exit flash
mode.
4. Breathing Lamp
No matter if the device is on or off, press the switch three times to turn on the green
breathing lamp. Click three times to turn it off.
5. Locking and Unlocking
When the light is off, press the switch four times. The light will blink three times to
indicate the lockout status. Any further operations on the device will activate a blue light
in the switch to indicate the lockout status, with the exception of another four presses of
the switch, which will unlock the device and set it to Low operation mode.
6. Charging
Take out the battery pack, connect the Type-C charging cable with the battery pack and
an adapter of 5V/2A to charge. It takes about 12h to fully charge the light (based on
5V/2A adapter)
7. Charging Status Indication
Charging
Red light on
Charging finished
Green light on

5
8. Charging Status Indication
C ≥90%
Blue light on (turns off after 5s)
90% > C ≥ 40%
Blue light flashes (turns off after 5s)
40% > C ≥ 15%
Red light on (turns off after 5s)
15% > C ≥ 0
Red light flashes
Parameters
FL1
Standard
Turbo
High
Med
Low
Strobe
SOS
12000
2600 LM
4000
2600 LM
1000LM
20LM
12000LM
00LM
1 min
+ 3.6
hours
4
hours
11
hours
23
days
/
/
4200m
1m
40900cd
IP68 (2m underwater for 1h)
447g / 15.77oz (without battery) | 795g / 28.04oz (with battery)
215mm ×68mm | 7.58in × 2.4in (L × D)
All data is derived from experiments of WUBEN lab according to the ANSI/NEMA FL1
standard, results may vary because of different experimental equipment, experimental
environment or other factors. The experiments are based on 2 pieces of WUBEN 18650
Li-ion batteries (3400mAh).

6
Maintenance
•The O-Ring may be damaged after long time use. Please replace the O-Ring in time to
ensure the waterproofness of the product.
•Please use WUBEN batteries or WUBEN recommended batteries.
•When the flashlight indicates low power, please charge or replace the battery in time
to avoid affecting the durability of the battery.
•Please use alcohol and a rag to clean the conductive parts of the flashlight.
•When not in use for a long time, please remove the battery to prevent the battery
from leaking or exploding. Store the flashlight in a dry and ventilated place.
•Never use concentrated or abrasive cleaners on the lamp housing.
FAQs
Problems
Causes
Solutions
Abnormal flash
or failure to
turn on
Check whether the flashlight is
not locked.
Unlock the flashlight.
Check if the switch is turned on
correctly.
Turn on the switch.
Check if the product is correctly
assembled.
Tighten the parts.
Check whether the battery is
not low on power.
Try the battery on other
products.
Check if the battery is not
reversed.
Remove the battery and
reassemble the product correctly.
Check the conductive position
for dirt or any grime.
Clean the surface with alcohol.
Abnormal
noise
Check whether there isn’t any
foreign matter in the tube.
Pour out possible foreign matter.
Damage to parts.
Contact your seller.
If your problems still aren’t solved, please contact WUBEN headquarters for after-sales
service.

7
Warranty Policy
A new product purchased in the Alza.cz sales network is warranted for 2 years. If you
need repair or other services during the warranty period, contact the product seller
directly, you must provide proof of purchase with the original date of purchase.
The following are considered to be a conflict with the warranty conditions, for
which the warranty claim may not be recognized:
•Use of the product for a purpose other than that for which the product is intended
or failure to follow the instructions for maintenance, operation and service of the
product.
•Damage to the product due to a natural disaster, the intervention of an
unauthorized person or mechanically through the fault of the buyer (eg during
transport, cleaning by inappropriate means, etc.).
•Natural wear and aging of consumables or components during use (such as
batteries, etc.).
•Exposure to adverse external influences, eg sunlight and other radiation or
electromagnetic fields, ingress of fluid or object, mains overvoltage, voltage
generated by electrostatic discharge (including lightning), faulty supply or input
voltage and inappropriate polarity of this voltage, chemical processes, e.g. used
power supplies, etc.
•If modifications, alterations, design changes, or alterations have been made by
anyone to change or extend the product's features over the purchase or use of non-
genuine components.
•Copies of proof of purchase of the product, altered, supplemented, without the
original data or otherwise damaged documents on the purchase of the product will
not be considered as documents proving the purchase of the claimed product.

8
EU Declaration of Conformity
Identification data of the manufacturer's / importer's authorized representative:
Importer: Alza.cz a.s.
Registered office: Jankovcova 1522/53, Holešovice, 170 00 Prague 7
IČO: 27082440
Subject of the declaration:
Title: Rechargeable LED flashlight
Model: A9
The above product has been tested in accordance with the standard (s) used for
demonstrationin accordance with the essential requirements laid down in the
Directive (s):
Directive No. 2014/30 / EU
Directive No. 2011/65 / EU as amended by 2015/863 / EU
Prague, 7/23/2020
WEEE
This product must not be disposed of as normal household waste in accordance with
the EU Directive on Waste Electrical and Electronic Equipment (WEEE - 2012/19 / EU).
Instead it shall be returned to the place of purchase or handed over to a public
collection point for the recyclable waste. By ensuring this product is disposed of
correctly, you will help prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inappropriate waste handling of
this product. Contact your local authority or the nearest collection point for further
details. Improper disposal of this type of waste may result in fines in accordance with
national regulations.

9
Manufacturer
SHENZHEN SHENGQI LIGHTING TECHNOLOGY CO., LTD.
E-mail: [e-mail]
Web: www.wubenlight.com
Address: 202#, Building A, Jihe E-Business Park, No. 33 Yangmei Road, Bantian Street,
Longgang District, Shenzhen, China
Importer
Alza.cz a.s.
Jankovcova 1522/53, Holešovice
170 00 Praha 7
www.alza.cz
All rights reserved. ©2020 alza.cz