Xiaomi ZI5 User manual

ZIAA/AAA Ni-MH Battery
Charger
Thank you for your choice!
Before using the device, read
the instructions carefully.
Caution
During charging, do not put anything on the device.
Do not recharge batteries, that is not designed for
this devices.
For optimum e󰀩ciency, it is recommended to use
the device with ZIAA / ZIAAA nickel rechargeable
batteries or nickel rechargeable batteries
Panasonic eneloop.
It is not recommended to take the device by wet
hands.
Do not immerse the device in water, do not let it
exposed to rain, snow, heat and avoid its use in
wet areas (eg bathroom).
After recharging, make sure you unplug the power
cord from the power supply.
If the product has been dropped or has other
damage, do not use it.
Do not disassemble or modify the device.
Do not use the device in direct sunlight.
Specications
Model: РВ400
Input: 5.0V-1.0A
Output: 5.0V-0.5A
(АА) 1.5V-550mA х4
(ААА) 1.5V-225mA х4
Dimensions: 77х63х24.5mm
Temperature range: 0-40 С
Introduction to ZI5 Ni-MH Battery
Charger
USB port(input)
The switch for charge / discharge
Set aside Input, to charge the rechargeable
batteries
Set aside Output, to charge another device
LED indicator
Anode
АА cathode
ААА cathode
Charging
Toggle the button to Input, charge the
rechargeable nickel batteries such as
AA and AAA (any combination).
1. Make sure that you have correctly
inserted the batteries (the direction of
the positive and negative poles of the
battery relative to the device).
The image of the installation of AA batteries
The image of the installation of AAA batteries
2. Recharge the rechargeable batteries
by connecting the USB device port to the
Micro Power DC 5V.
3. Slowly ashing LED indicates normal
charging process; lLED, that constantly
lit indicates that battery charging is
complete.
XIAOMI-MI.COM

XIAOMI-MI.COM
In the following table you will nd general information about a charging
duration. These data may vary depending on the temperature and current
battery status.
• These results obtained under the following conditions: Input 5V / 1A, a
full battery charge. The duration of the battery charge may depend on the
level of residual charge and ambient temperature.
• Note that a total charging time will increase if during the process of
charging you added new batteries.
• It is possible that after a full charge the battery, the LED will light up
again and the unit will start to re-charge it. To determine the overall level
of battery power and cut o󰀨 power supply, the device needs a certain time.
This is not a malfunction of the charger or the rechargeable battery.
Charging of other devices if needed
Toggle the button to Output when using AA rechargeable
batteries, in case of urgent need to recharge other devices.
1. Insert 4 AA batteries (for maximum e󰀩ciency, use a fully
charged batteries. Insu󰀩cient battery charge level can reduce
the output power).
2. LED lights start to ash in succession, pointing to the
normal discharge process.
3. To recharge other devices in case of emergency Battery
Charger supports 5V-500mA output current.
LED indicators
Charging duration
XIAOMI-MI.COM

The presence of toxic and hazardous substances
Parts Токсичные и опасные вещества и элементы
Pb
Hg Cd Cr PBBs PBDEs
Circuit board x o o o o o
Housing o o o o o o
Tapes,
gaskets and
other small
components o o o o o o
0: toxic and harmful substances in all components of the device are contained in an amount below
the limit value according to SJ / T11363-2006 «limit the requirement for toxic and hazardous
substances in products.»
X: indicates the presence of toxic and harmful substances, at least one of the components of this
product in excess of the limit value, according to SJ / T11363-2006 «Requirements limiting the
presence of toxic and hazardous substances in products.»
This product complies with European RoHS requirements and standards for environmental
protection; international relevant organizations still can not replace or reduce the lead content in the
printed circuit board and other components of the device.
The environmentally sound management of the timing indicates that under normal operating
conditions is not possible leakage of hazardous substances or elements of the device and its
components. When consumers use electronic information devices have no harmful e󰀨ects on the
environment and on human health, they can not cause any serious injuries.
XIAOMI-MI.COM

Find and x faults
Warranty
Warranty service is carried out in accordance with the law on «the
rights of consumers of China» and «the quality of Chinese products
of the Law.» The warranty service includes:
During the warranty period, you have the right to repair, exchange
or return an item. For repair, replacement or return of goods you
need to present a receipt.
1. In the case of unjustied return the goods within 7 days after the
purchase, the buyer bears the cost of its transportation;
2. In the event of a breakdown of the «fault list», after the
verication and determine the cause of the problem, you can use
the following services:
List of faults
Terms that are not included in the warranty service
1. Service term is over, falling, neglect, abuse, liquid ingress, an
accident, if torn or slipped label and labeling devices;
2. The warranty period has expired;
3. Damage caused by force majeure;
4. Failures, which not correspond to the «List of faults» of Xiaomi
center service;
5. The failure of the device or its components from the «Fault
list», which arose in connection with the human factor, and which
interfere with normal operation.
Manufacturer: OOO «Jiangsu Zimi Technology»
Address: Jiangyang, Chengjiang str. 159. A913
XIAOMI-MI.COM