Xylem LOWARA DOMO User manual

Installation, Operation
and Maintenance manual
DOMO
DOMO GRI
DOMO, DOMO GRI
Submersible pump u
nits

en – Original instructions
10 DOMO, DOMO GRI - Installation, Operation and Maintenance Manual
Position
number
Description
Position
number
Description
1
Model
7
Maximum liquid temperature
2
Flow rate range
8
Rated output
3
Head range
9
Minimum head
4
Motor data
10
Maximum immersion depth
5
Manufacturing date
11
Serial number
6
Pump unit code
3.4 Identification code
Figure 3: DOMO
Position
number
Description
Notes
1
Series name
2
Rated output
HP x 10
3
Frequency
Empty = 50 Hz
6 = 60 Hz
4
Impeller type
Empty = two-channel
VX = vortex
5
Phase
Empty = single phase
T = three-phase
6
Version
7
Float switch
Empty = with float
GT = with tube float
SG = without float
Figure 4: DOMO GRI
Position
number
Description
Notes
1
Series name
2
Rated output
HP x 10
3
Frequency
Empty = 50 Hz
6 = 60 Hz
4
Phase
Empty = single phase
T = three-phase
5
Version
6 Flow Empty = standard
HF = high flow rate
7
Float
Empty = with float
SG = without float
1
2 6
DOMO 6/B GT 10 TVX
3 5 7
4
DOMO_M0007_A_sc

en – Original instructions
DOMO, DOMO GRI - Installation, Operation and Maintenance Manual 15
3. DOMO GRI series only:
a) Remove one of the three support feet by unscrewing the M8x25 screw.
b) Re-tighten the screw.
Tightening torque: 13 Nm (115 lbf·in).
c) Repeat a) and b) for the other two feet.
4. Install the unit:
a) Screw the discharge port to the sliding bracket, placing the seal included in the kit
between the two.
b) Attach the chain to the handle.
c) Slide the sliding bracket through the guide pipes and lower the unit in the tank,
supporting it with the chain until the end.
d) Attach the end of the chain to the edge of the tank.
e) Secure the supply cord to the edge of the tank with a stop.
6
4
1
9
8
5
7
2x
4x
2x
2
3
DOMO_M0002_A_de