®
PlateMate Installation
ITEM COMPONENT QTY
1. Back Plate x1
2. Knurled Nuts x2
3. Screws x2
4. Velcro Straps x3
• Please read instructions carefully before installation.
• Check the contents of kit. Contact your YAKIMA
dealer if any parts appear missing or damaged.
• Place these instructions in the vehicle’s glove box
after installation is complete.
FIRST TIME INSTALLATION
INSERT VELCRO STRAPS
Take x2 Velcro Straps and thread through
the front of PlateMate as shown.
1
Pull Velcro Straps completely
through as shown.
1
2
3
4
NOTE:
Strap configuration
shown is for Yakima
HoldUp.
PlateMate can
also be attached
to other carriers
using the other slot
combinations.
KIT CONTENTS
6100003124-Rev1
POSITION NUMBER PLATE
Position your number plate onto the
PlateMate. Using the x2 Screws,
line up the Screws through slots
in your number plate with the
appropriate holes in PlateMate.
2
SECURE NUMBER PLATE
Turn PlateMate over carefully ensuring
that the screws don’t fall out. Spin
the Knurled Nuts onto screw threads.
Finger tighten nuts until number
plate is secure on PlateMate.
3
6100003124-Rev1
