Yanmar YD25 User manual

YD25
INSTRUMENT PANEL
INSTALLATION MANUAL
Dimensions
Contents of box
Contents POS Quantity
Bezel
A 1
YD25 panel
B 1
Gasket
C 1
Spinlock Nut
D 1
Sun-cover
E 1
Installation
manual F 1
ABCD
EF

Installation (Panel)
NOTE:
Before installation, please confirm that dashboard (X) thickness is less than
15 mm (0.6”).
1. Drill a hole with a diameter of 53 mm (2.1”) (If necessary, please use the
hole cutting template).
2. Remove the protective sheet from the gasket (D) and attach the gasket to
the dashboard (X).
3. After installing the gasket, insert the YD25 display (C) in the hole.
4. Screw and fix the nut (E) from the backside with tightening torque 4 Nm
(2.95 lbf ft). Note: for dashboard thickness > 5 mm insert the nut with the
thread side first.
5. Connect the wire harness.
6. Place the bezel (B) on the front of the panel and press it in until a click
sound is heard.
7. Attach the sun cover (A) to protect the display.
8. For operating instruction and setup, please see Operation Manual
(164100-29010)
164100-29000
A
C
B
D
X
E

Connect YD25 display with the harness as shown below:
or
To Engine
Extension Harness
164000-22210
164000-22220
164000-22230
164000-22240
Extension Harness
164000-22210
164000-22220
164000-22230
164000-22240
Terminator
164000-29000
YD25 Harness
164100-21030
YD25
Panel
Accessory Power
Fuse (3A)
Fuel tank sensor
Buzzer
Next
Helm
Connect
Connect
Connect
(push red tab to
lock) 0-190Ω(EU type)
240-33Ω(US type)
12VDC: 3A Max
Red Black
12VDC Ground
Mating
Connector:
DT06-2S
(TE)
21 12
Installation (Harness)

Ø53mm (2.09”)
66.0mm (2.60”)
82.5mm (3.25”)
Outline of
the Panel
Hole cutting template
NOTE:
Please check the dimensions before using the template