YitaHome BFBPBA-0001 User manual

ASSEMBLY INSTRUCTIONS
BIDET ATTACHMENT
Pure & Easy
CONTACT US:
If you have any questions about the installation of YITAHOME® products，just contact us
at [phone] from Mon-Fri 8:00 AM-16:30 PM PST / Saturday 8:00 AM-12:00 PM PST
(except holidays) or E-mail us at: [e-mail]
Alternative method to contact us(amazon.com orders only)
1.Log into your amazon account
2.Go to "Your Orders" and find the purchase
3.Click on "Contact Seller"
BFBPBA-0001

ASSEMBLY INSTRUCTIONS
1 2
ASSEMBLY INSTRUCTIONS
Notice:
1: Please read this manual thoroughly before installation. Keep it after installation is completed in
case it is needed later.
2: Confirm that you can access the filling valve under the toilet tank. If not, contact our
customer support ASAP.
3: Confirm that the toilet tank’s water supply pipe is flexible. If not, immediately replace it with
a flexible one.
BFBPBA-0001
BFBPBA-0001
Function Parts:
Parcel List:
The extra installation tools you may needed:
Water pressure
/Function select
control knob
Cold water inlet
Seat(seat hook)coupling hole
Rear washing nozzle
Steel Hose Instruction ManualT-adapterTeflon tape
Flat screwdriver Wrench
Bidet attachment main body
User
Manual
6 inch
1.95 inch
16.88 inch
8.15 inch
2.28 inch

ASSEMBLY INSTRUCTIONSASSEMBLY INSTRUCTIONS
3 4
1. Turn off the toilet tank’s water supply and flush it to completely
empty the toilet tank. 3. Place the bidet attachment on the toilet. The adjustment plates must line up with corresponding holes on the toilet bowl.
2. Remove the toilet seat using a slotted screwdriver to unscrew t
he toilet seat bolts while holding the underside nuts in place. 4. Reattach the toilet seat on the top of the bidet attachment and secure it using hardware.

ASSEMBLY INSTRUCTIONSASSEMBLY INSTRUCTIONS
5 6
Instructions
Congratulations! This YITAHOME bidet is ready to be used.
Firstly, please make sure all parts are tightened without leaks or movement.
Secondly, please confirm the bidet are in good condition. If not, please read
the "Troubleshooting" for solutions or contact our customer
service: [email protected]
1. Switch to "Wash" and you will hear a click sound to designate rear washing
2. Switch to "Nozzle" with click sound for cleaning nozzle
Adapter
Valve
Flexible hose
Bidet
5.
Disconnect the water supply
hose from toilet tank.
Connect the top of the T-adapter
to the toilet tank and the bottom
of the T-adapter to the water
supply hose.
6.
Connect the bidet hose to the
T-adapter and bidet inlet.
Use a wrench to fully tighten
connections on both ends
of the hose.
1. Knob switch to toggle washing modes
1 2 3
1. Increase water pressure: rotate the knob to be away from “OFF” icon
2. Decrease water pressure: rotate the knob to approach “OFF” icon
2. Knob switch to set water pressure
3. Knob switch to the middle("OFF") to turn off the bidet and
you will hear a click sound.
Wash
OFF
Nozzle Wash
OFF
Nozzle Wash
OFF
Nozzle Wash
OFF
Nozzle
Wash
OFF
Nozzle
Notes
- Do not flush the toilet when bidet is in use.
- Don't connect the bidet to heat water supply. It should only be connected
to cold water.
- Gently adjust the water pressure. Avoid the highest pressure to reduce the
risk of injury.