1. Way of programming first transmitter depends on type of radio receiver. When programming first transmitter please
follow instruction of the device that is going to be controlled by the transmitter.
2. Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
3. Programming transmitter using this ethod will result in deleting receiver memory.
4.Pressing the programming button can not be done by using sharp tools.
1. Estimated battery lifespan is 3 year if the device runs 4 commends a day in average.
2. Batteries should be changed when LED diode stops flashing when channel is being changed or receiving device stops
reacting to commands.
3. Channel selection is made by pressing the number button and confirmation of the action is LED illumination. It is possible
to select and control several channels.
4.In order to replace the battery, carefully pry open the remote control case at its bottom.
Batteries contain substances that may be hazardous to health and may pollute the environment. Used batteries should
be disposed of properly.
Turn on power supply
or press microswitch
(for 2 sec.) when
power is on.
Motor will make a sound.
Roller shutter will make
an up/down move.
Motor will
make a sound
Press
programming button
(P2) on the remote.
lub
Roller shutter
will make an
up/down move
and the motor
will make a few
short sounds.
Motor will
make a sound.
Press
programming button
(P2) on the remote.
Press
UP button
on the remote.
3. Programming first transmitter to R-type motors
2
