Zest 4 Leisure Large Log Store Pressure Treated User manual

V3-10.15
ASSEMBLY INSTRUCTIONS
1.84m x 0.70m x 1.30m
Product Name: Large Log Store Pressure Treated
PLEASE KEEP THESE INSTRUCTIONS
Pressure Treated products should not be treated with any other products for the first month.
Zest4Leisure
01352752555 - [e-mail]

Large LogStore Assembly Instructions
Requires 2 person assembly.
Toolsrequired:- Corded/ Cordless Drill,Tape Measure, Pozidrive
Bit/Screwdriver,Spirit Level. 3mm Drill Bit required in order for
you to drill all screw holes before construction.
Log Store Fixings List
Item
Description
Quantity
A
4x40mm Screws
6
B
4x60mm Screws
8
c
Floor
1
D
Left & Right Sides
2
E
Back Corner Supports
2
F
Lathed Roof
1
1) Position part C on aflat surface
2) Position part Dwith the lowest angle to the back ensuring board overlaps base.
Using 3mm drillbit, pre drill 3 holes across overlap board.
Using 3no itemA screws fix side to base,repeat on opposite side.

3) Place Roof (Item F) across both sides evenly and using a spirit level ensure end panels are straight.
With a tape measure, measure from outside of roof measure 70mm in,this is the external overlap.
Using 3mm drill bit drill all four corners as shown in the photograph using 4x60 screws (Item B)
Place inpredrilled holes.
4) Place Back corner supports (Item E)as shown in photograph. Predrill holeswith 3mm drill bit.
Usingtwo 4x60mm screws (Item B) screw brackets into place. Repeat onopposite side.
The assembly isnowcomplete.