Zest 4 Leisure Log and Tool Store User manual

1.87m x 0.70m x 1.90m
Item Code : Log and Tool Store
ASSEMBLY INSTRUCTIONS
PLEASE KEEP THIS INSTRUCTION
Zest4Leisure
08458902357 - [email protected]

Log and Tool Store Assembly Instructions
Requires 2 person assembly. All screw holes to be pre-drilled.
Tools required:- Corded/ Cordless Drill, Tape Measure, Pozidrive
Bit/Screwdriver, 3mm Drill Bit, Spirit Level.
Item Description
Floor / Base Panel
Slatted Side Panel
Inner Wall Panel
Side Wall Panel
Back Panel
Roof
Hinged Door
Shelf Timbers
Bracing Timbers
Fixings
45mm Screws
60mm Screws
35mm Screws
70mm Screws
Tower / Sliding Bolt
4
2
1
1
1
1
1
1
6
2
1
24
10
1
Quantity
A
B
C1
C2
D
F
G
H
E
A
BC2 C1
DF
E
G
1)
H
Please note: Roof orientation as illustrated in these instructions is correct
(Picture of product in Brochure # 5 is incorrect).

2)
4)
5b)
6)
5a)
3)
B
A
C1
C2
D
Pre drill x2 bottom board of side panel and fix to
base panel using 2no 45mm screws
Measure 505mm from end of base. Pre drill Repeat as shown in picture 3
bottom rail of inner panel 70mm in from both ends
(Marked with X) and fix using 2no 60mm screws
Place panel ‘D’ as show.Pre drill 6 holes 100mm from
top and bottom with one in the centre (Marked X)
505 mm

7) 7a)
7b)
8a) 9)
8)
E
Position roof section ‘E’ with 70mm overhang on
both sides
Fix back panel ‘D’ using 6no 35mm screws.
Back panel ‘D’ should be positioned 70mm
lower than wall panels ‘C1’ and ‘C2’
Pre drill roof section (front and back) in line with side
and wall panels and attach using 6no 70mm screws
70mm
70mm

9a)
9c)
9e) 10)
9d)
9b)
F

10a)
11) 11a)
11b) 11c)
10b)
Hang door using 35mm screws
starting with top hinge
Place braces as shown to the back of store and fix
Position and pre drill bracings as shown Position bracing and pre drill roof as shown
using 2no 70mm screws per bracing
Repeat on bottom hinge
H
H

13)
12a)
Attach tower sliding bolt to the door, align the receiver and fix using screws provided
Set out 6no Shelf Timbers on support battens and fix using 2no 35mm screws per board