Zeus Appollo Z20I1K User manual

USER MANUAL
340-00089-04
Phone: [phone]
Beijing Hua Xin Liu He Investment (Australia) Pty Ltd.
Brisbane Office
32 Cr
Banyo, QLD 4014
ockford Street
Phone: [phone]
Fax: [phone]
Email: [e-mail]
Perth Office
Phone: [phone]
Email: [e-mail]
789 Wellington Street, West
Perth, WA 6005, Australia

If there are more than 3 PV strings on input side, an additional fuse installing will be suggested.
An earthing photovoltaic system need to connect an Arc fault detector on DC side.
The inverter can exclude the possibility of DC residual currents to 6mA in the system, Where an external RCD is required
in addition to the built-in RCMU, type A RCD must be used to avoid tripping。
The PV- is not grounded as default configuration.
Zeus Appollo Solar
1-3K 3-5KD
Single-MPPT Dual-MPPT series refer to Figure3.2.1-2
in after

1-3k .and 2 pairs of DC connectors in 3-5k.
。
Single-MPPT series
Dual-MPPT series
Single-MPPT series referred to Figure 3.3.2-4, 3.3.2-5.Figure Dual-MPPT series
accessory bag.
referred to Figure 3.3.2-6, Figure3.3.2-7.

please install an independent two
Z20I1K/Z20I1K5/Z20I2K/Z20I2K5
Z20I3K/Z20I3KD/Z20I3K6D
Z20I4K2D/Z20I4K6D/Z20I5KD
forbidden
3.4.3-2.
Single-MPPT
Dual-MPPT series

3.4.4-1
inverter, shall not use it for any other purposes.

www.z20monitoring.zeusappollo.com to create PV station.

Z20IXXXD
display only one pair Vpv and IpvSingle-MPPT series
The inverters must be programmed with the Safety Country of Australia prior to connecting to the grid.

please
Zeus Appollo Solar
Z20I1K Z20I1K5 Z20I2K Z20I2K5 Z20I3K

Z20I1K Z20I1K5 Z20I2K Z20I2K5 Z20I3K Z20I1K Z20I1K5 Z20I2K Z20I2K5 Z20I3K
3990
Max.DC Input Power(W)
Max.DC Input voltage(V)
Start-up
MPPT Range for Full Load (V)
Nominal DC Input Voltage (V)
Max. Input Current (A)
Max. Short Current (A)
No.of MPP Trackers
No.of Input Strings per Tracker
PV String Input Data
Nominal Output Power (W)
Max. Output Apparent Power (VA)
Nominal Output Voltage (V)
150-550
360
11/11
13.8/13.8
2
1
220~230
Nominal Output Frequency(Hz)
Max. Output Current (A)
Output Power Factor
Output THDi (@Nomina Output)
50/60
13.6
~1(Adjustable from 0.8 leading to 0.8 lagging)
Europe efficiency
97.8%
600
80~550
120
3000
3000
97.5%
PV Over Current Protection(A)
DC overvoltage category
PV Backup Current(A)
AC overcurrent protection (A) 20
25/25
Technical Data
AC overvoltage category(A)
Maximum output fault current
A.C. (peak and duration)
Output Inrush Current
(peak and duration)
AC Backfeed Current(A)
Category III
0
50A 100μs
25A 5μs
Z20I3KD
4788
180~550
360
1
220~230
50/60
16
600
80~550
120
11/11
13.8/13.8
2
3680
3680
24
25/25
Z20I3K6D
5586
210~550
360
1
220~230
50/60
19
600
80~550
120
11/11
13.8/13.8
2
4200
4200
Category II
0
29
25/25
Z20I4K2D
6650
250~550
360
1
220~230
50/60
600
80~550
120
11/11
13.8/13.8
2
5000（ ）4999*
5000（4999*）
35
25/25
22.8(21.7*)
Z20I5KD
Note(s):*4999 and 21.7A for Australia.

Examples
E932
Operating Altitude(m)
User Interface
Communication
Size Width*Height*Depth mm( )
self
≤4000
al
LCD&LED
VDE-AR-N 4105,
VDE0126-1-1
EN50438(PL),
EN50438(SW),G83,
IEC61727,AS4777.2
IEC62116
EN6100-6-1,EN61000-6-2,EN61000-6-3,EN61000-6-4
Technical Data
14
347*432*145mm
VDE-AR-N 4105
VDE0126-1-1
EN50438(PL),
EN50438(SW),G59,
IEC61727,AS4777.2
IEC62116
VDE-AR-N 4105
VDE0126-1-1
EN50438(PL),
EN50438(SW),G59,
IEC61727,AS4777.2
IEC62116,MEA,PEA
Moisture location category 4K4H
Environment category Outdoor＆Indoor
External environment pollution degree Grade1、2、 3
AS4777.2
Insulation Resistor Detection
Residual Current Monitoring Unit
Output Over Current Protection
Output Short Protection
Output Over Voltage Protection
Operating Temperature Range(℃)
Anti-islanding Protection
Input Reverse Polarity Protection
Integrated (AFD)
Storage Temperature (℃)-30~65
High Frequency Isolation
IEC62116 IEC61727
IEC62109-1/-2
Z20I3KD Z20I3K6D Z20I4K2D Z20I5KD