ZKTeco GL300 User manual

Installation Guide
Version: 1.0
GL300

1
Part APart B
Pack list
Screws Sticky board

indoor
2
Installation
1. Peel the sticker off the
mounting plate and stick it at
the appropriate height
2. Remove screws from GL300
Part A

3
3. Detach the cable 4. Install the outdoor unit and
tighten the screws
rear panel
cable
the front panel
Pull out the
buckle

4
5. Secure Part A with the screws 6. When installing Part B, make
sure that it is at the same
height as Part A
Part B Part A
insert the cable
Note: Please be carefulwhile connecting the cable.

7. Unfasten and remove screws
from Part B
8. Install Part B outdoor unit
on the glass door and fix it
with the screws
Part B
5

6
9. Install indoor unit on the glass
door and secure with the screws
10. Install four batteries and
fix the cover
reset button

7
How to change door open direction
remove the screws
rotate the mounting bracket
and indoor unit 180° reinstall the screws

ZK Building, Wuhe Road, Gangtou, Bantian, Buji Town,
Longgang District, Shenzhen China 518129
Tel: [phone]
Fax: [phone]
www.zkteco.com
© Copyright 2018. ZKTeco Inc. ZKTeco Logo is a registered trademark of ZKTeco or a related company. All other product and company names mentioned are used
for identification purposes only and may be the trademarks of their respective owners. All specifications are subject to change without notice. All rights reserved.