ZOLL 731 Series Quick start guide

6/26/2019
1
ZOLL 731
Easy Set Up Guide
2
Vent Overview
Startup Switch
Vent parameter buttons
Confirmation button
Alarm Silence/ Cancel Action
Rotary Selection Knob
Single Manual Breath
Vent Status Indicator

6/26/2019
2
3
Start-up
1. Rotate knob to right
2. Self test auto runs; light
should turn green
4
Select mode
1. Push button once to
highlight mode
2. Rotate knob to “AC”
3. Press confirm button
4. Push button twice to
highlight control method
5. Rotate knob to “(V)”
6. Press confirm button
Should default to AC (V), if not
follow steps below.

6/26/2019
3
5
Set Respiratory Rate
1. Push button to highlight
BPM
2. Rotate knob to desired rate
3. Press confirm button
4. Press button twice to
highlight High alarm
5. Rotate knob to 10 above set
6. Press confirm button
7. Press button three times to
highlight Low alarm
8. Press confirm button
6
Set Volume
1. Press button once
2. Rotate knob to desired
Volume (see VT chart if
unknown)
3. Press confirm button

6/26/2019
4
7
8
Set Pressure Alarms and PEEP
1. Press button once
2. Rotate knob to select high
pressure 10-15 higher than
outlined number (not > 40)
3. Press confirm button
4. Press button twice
5. Rotate knob to select low
pressure 10-15 below
outlined number
6. Press confirm button
Peep defaults at 5; If different
PEEP desired, press button
three times and select desired
PEEP

6/26/2019
5
9
Set FiO2
1. Press button once
2. Rotate knob to desired FiO2
3. Press confirm button
ABG and Vent Changes
• Normal Ranges
– pH 7.35-7.45 PaCO2 35-45 HCO3 22-26
PaO2 80-100
• Increase RR or VT to lower PaCO2/ increase pH
• Decrease RR or VT to raise PaCO2/ lower pH
• Increase FiO2 or PEEP to raise PaO2
10