MF659 Q ick G ide
Confidential and Proprietary Information of ZTE CORPORATION 5
ZTE nder the above-mentioned sit ations.
•
This warranty is End User’s sole remedy and ZTE’s sole liability for defective or nonconforming items,
and is in lie of all other warranties, expressed, implied or stat tory, incl ding b t not limited to the
implied warranties of merchantability and fitness for a partic lar p rpose, nless otherwise req ired
nder the mandatory provisions of the law.
Limitation of Liability
ZTE shall not be liable for any loss of profits or indirect, special, incidental or conseq ential damages
res lting from or arising o t of or in connection with sing of this prod ct, whether or not ZTE had been
advised, knew or sho ld have known of the possibility of s ch damages, incl ding, b t not limited to lost
profits, interr ption of b siness, cost of capital, cost of s bstit te facilities or prod ct, or any downtime
cost.
FCC Compliance
•
This device complies with part 15 of the FCC r les. Operation is s bject to the following two conditions
(1) This device may not ca se harmf l interference, and
(2) this device m st accept any interference received, incl ding interference that may ca se ndesired ope
ration.
•
This device has been tested and fo nd to comply with the limits for a Class B digital device, p rs ant to
Part 15 of the FCC R les. These limits are designed to provide reasonable protection against harmf l
interference in a residential installation. This eq ipment generates ses and can radiate radio freq ency
energy and, if not installed and sed in accordance with the instr ctions, may ca se harmf l interference
to radio comm nications. However, there is no g arantee that interference will not occ r in a partic lar
installation If this eq ipment does ca se harmf l interference to radio or television reception, which can
be determined by t rning the eq ipment off and on, the ser is enco raged to try to correct the
interference by one or more of the following meas res:
Reorient or relocate the receiving antenna.
Increase the separation between the eq ipment and receiver.
Connect the eq ipment into an o tlet on a circ it different from that to which the receiver is
connected.
Cons lt the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance co ld void
the ser‘s a thority to operate the eq ipment.
•
The antenna(s) sed for this transmitter m st not be co-located or operating in conj nction with any
other antenna or transmitter.
Radio Frequency (RF) Energy
This model device meets the government’s req irements for expos re to radio waves.
This device is designed and man fact red not to exceed the emission limits for expos re to radio
freq ency (RF) energy set by the Federal Comm nications Commission of the U.S. Government:
The expos re standard for wireless devices employs a nit of meas rement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for SAR are cond cted sing
standard operating positions accepted by the FCC with the device transmitting at its highest certified
power level in all tested freq ency bands. Altho gh the SAR is determined at the highest certified power
level, the act al SAR level of the device while operating can be well below the maxim m val e. This is
