2K Furniture Designs D503 User manual

NOTE TO CUSTOMERS:
For ease and speed of assembly we recommend that before you commence each step of the
assembly that you identify all the parts required to complete that step.
We recommend that where possible you allow sufficient space to assemble the item as close
as possible to the place where it will be once assembled.
For the protection of your furniture we recommend that the product is placed on protected
surfaces during assembly to prevent any damage.
During assembly do not over tighten the screws or bolts, as this may damage the product.
Please ensure you retain all the product packaging until the item is completely assembled.
Periodically check all fitting and re-tighten as necessary.
Never allow any liquids to remain on your furniture as absorption can cause the wood to warp
or finish to de-laminate.
It is recommended that this item should be assembled by two adults.
ASSEMBLY INSTRUCTIONS
MODEL #D503 COUNTER DINING TABLE
PAGE 1 OF 3

PAGE 2 OF 3
ASSEMBLY INSTRUCTIONS ITEM # D503 DINING TABLE
PARTS IDENTIFICATION
A- Table Top 1 pc
B- Leg Frame 2 pcs
C - Aprons 2 pcs
D- Upper Shelf 1 pc
E- Bottom Shelf 1 pc
HARDWARE IDENTIFICATION
1- JCBC Bolt M6 x 50mm 4 pcs
2- Spring Washer 4 pcs
3- Allen Key 1 pc
4- Screw M4 x 32mm 8 pcs
5- Screw M4 x 45mm 8 pcs
NOTE: Quantities shown are for one table.
Ø8mm
2 ”
Ø 1/4”
1 1/8”
Ø4mm
1 3/4”
Ø4mm

PAGE 3 OF 3
ASSEMBLY INSTRUCTIONS ITEM # D503 DINING TABLE
5
STEP 1 STEP 2
Repeat Step 1 to assemble the other side
of leg frame.
STEP 3
8x
4
E
D
C
B
B
A
MARKING LINES
Place Table Top upside down, Place the table base within the marked lines on the table top.
Make sure veneer grain in table top and shelves are parallel.
Use screw (5) to attach table base. Make sure all screws are fully tightened before turning the
table upright.
grain direction
2
1
3