3M DBI SALA OSHA 1926.502(d)(12) User manual

© 3M 2019
OSHA 1926.502(d)(12)
OSHA 1926.502(d)(16)(iv)
OSHA 1926.502(d)(16)(ii)
OSHA 1910.140 INSTRUCTION MANUAL
5902147 REV. J
COUNTERWEIGHT CLIMB ASSIST
Climb Assist/Fall Arrest System
1
2
3

2
2
1
3
2
4
5
9501600
9503194
9501599
4x 1/2” 7-1/16”
7-1/16”
1
2
3
5
2104153
1200017
1200014
4

3
3 4
A. B. C. D.
E. F. G.
A B C
5

4
6
A
B

5
7
A
B
C
≤4 ft
20-25
ft-lbs
20-25
ft-lbs
8
B
H45° 60° 75°
40 ft.
(12.2 m)
57 ft.
(17.4 m)
46 ft.
(14 m)
41 ft.
(12.5 m)
C
50 ft.
(15.2 m)
71 ft.
(21.6 m)
58 ft.
(17.7 m)
52 ft.
(15.8 m)
60 ft.
(18.3 m)
85 ft.
(25.9 m)
69 ft.
(21 m)
62 ft.
(18.9 m)
70 ft.
(21.3 m)
99 ft.
(30.2 m)
81 ft.
(24.7 m)
72 ft.
(21.9 m)
80 ft.
(24.4 m)
113 ft.
(34.4 m)
92 ft.
(28 m)
83 ft.
(25.3 m)
90 ft.
(27.4 m)
127 ft.
(38.7 m)
104 ft.
(31.7 m)
93 ft.
(28.3 m)
100 ft.
(30.5 m)
141 ft.
(43 m)
115 ft.
(35.1 m)
103 ft.
(31.4 m)
110 ft.
(33.5)
156 ft.
(47.5 m)
127 ft.
(38.7 m)
114 ft.
(34.7 m)
120 ft.
(36.6 m)
170 ft.
(51.8 m)
138 ft.
(42.1 m)
124 ft.
(37.8 m)
C
H
B

6
9
A B
C D

7
10
A
B
45° 60° 75°
130 lbs.
(59 kg)
100 lbs.
(45.4 kg)
90 lbs.
(40.8 kg)
80 lbs.
(36.3 kg)
C
140 lbs.
(63.5 kg)
109 lbs.
(49.4 kg)
97 lbs.
(44 kg)
87 lbs.
(39.5 kg)
150 lbs.
(68 kg)
117 lbs.
(53.1 kg)
104 lbs.
(47.2 kg)
93 lbs.
(42.2 kg)
160 lbs.
(72.6 kg)
126 lbs.
(57.2 kg)
111 lbs.
(50.3 kg)
99 lbs.
(44.9 kg)
170 lbs.
(77.1 kg)
134 lbs.
(60.8 kg)
118 lbs.
(53.6 kg)
106 lbs.
(48.1 kg)
180 lbs.
(81.6 kg)
143 lbs.
(64.9 kg)
125 lbs.
(56.7 kg)
112 lbs.
(50.8 kg)
190 lbs.
(86.2 kg)
151 lbs.
(68.5 kg)
132 lbs.
(59.9 kg)
118 lbs.
(53.5 kg)
200 lbs. - 310 lbs.
(90.7 kg - 140.6 kg)
160 lbs.
(72.6 kg)
139 lbs.
(63 kg)
124 lbs.
(56.2 kg)
A
B
C

8
11

9
12
THIS PRODUCT COMPLIES WITH THE FOLLOWING STANDARDS ONLY IF MARKED
WITH THE CORRESPONDING LETTER CODE UNDER "STDS" SECTION BELOW:
B = OSHA 1910.140 & 1926.502 D = ASTM F887 E = ANSI Z359.3 F = ANSI Z359.4
G = ANSI Z359.18 TYPE A H =
MATERIAL DESIGNATION:
(IDENTIFIED AFTER MODEL NO.)
P=POLYESTER - N=NYLO N
C=CABLE - W=CHAIN
K=ARAMID - B=BLEND
ANSI CAPACITY: 130-310 LBS (59-140kg)
LENGTH (FT.) IS DENOTED
BY NUMBER AFTER
MATERIAL DESIGNATION
PR ODUC TS MARK ED TO ANSI Z3 59. 18 TY PE A:
• MINIMUM BREAKING STRENGTH: 5,000 LBS
• MINIMUM SERVICE TEMP: -40°F ( -40°C)
THIS PRODUCT COMPLIES WITH THE FOLLOWING STANDARDS ONLY IF MARKED
WITH THE CORRESPONDING LETTER CODE UNDER "STDS" SECTION BELOW:
B = OSHA 1910.140 & 1926.502 D = ASTM F887 E = ANSI Z359.3 F = ANSI Z359.4
G = ANSI Z359.18 TYPE A H =
MATERIAL DESIGNATION:
(IDENTIFIED AFTER MODEL NO.)
P=POLYESTER - N=NYLO N
C=CABLE - W=CHAIN
K=ARAMID - B=BLEND
ANSI CAPACITY: 130-310 LBS (59-140kg)
LENGTH (FT.) IS DENOTED
BY NUMBER AFTER
MATERIAL DESIGNATION
PR ODUC TS MARK ED TO ANSI Z3 59. 18 TY PE A:
• MINIMUM BREAKING STRENGTH: 5,000 LBS
• MINIMUM SERVICE TEMP: -40°F ( -40°C)

10
MATERIAL IS DENOTED BY LETTER AFTER MODEL NUMBER
B = POLYPROPYLENE/POLYESTER BLEND N = NYLON
P = POLYESTER W = WIRE ROPE
LENGTH (FT.) IS DENOTED BY NUMBER AFTER MATERIAL
DESIGNATION
DIAMETER (IN.) IS DENOTED BY NUMBER AFTER LENGTH
DESIGNATION
CAPACITY: 310 LBS. MAXIMUM
DO NOT REMOVE THIS LABEL
THIS PRODUCT COMPLIES WITH THE FOLLOWING
STANDARDS ONLY IF MARKED WITH THE
CORRESPONDING LETTER CODE UNDER "STDS" SECTION:
B = OSHA 1910.140 & 1926.502
D =
ASTM F887
E = ANSI Z359.3
F = ANSI Z359.4 H = ANSI Z359.15
J =
MATERIAL IS DENOTED BY LETTER AFTER MODEL NUMBER
B = POLYPROPYLENE/POLYESTER BLEND N = NYLON
P = POLYESTER W = WIRE ROPE
LENGTH (FT.) IS DENOTED BY NUMBER AFTER MATERIAL
DESIGNATION
DIAMETER (IN.) IS DENOTED BY NUMBER AFTER LENGTH
DESIGNATION
CAPACITY: 310 LBS. MAXIMUM
DO NOT REMOVE THIS LABEL
THIS PRODUCT COMPLIES WITH THE FOLLOWING
STANDARDS ONLY IF MARKED WITH THE
CORRESPONDING LETTER CODE UNDER "STDS" SECTION:
B = OSHA 1910.140 & 1926.502
D =
ASTM F887
E = ANSI Z359.3
F = ANSI Z359.4 H = ANSI Z359.15
J =
COUNTER WEIGHT REQUIRED FOR THIS SYSTEM IS DEPENDENT UPON GUY
WIRE ANGLE AND USER'S BODY WEIGHT, SEE USER MANUAL.
MANUFACTURER'S INSTRUCTIONS SUPPLIED WITH THIS PRODUCT AT TIME OF SHIPMENT MUST
BE FOLLOWED. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEAT H.
CONTACT 3M FALL PROTECTION GROUP IF INSTRUCTION SHEET IS NEEDED.
INSPECT BEFORE EACH USE. DO NOT USE IF WEAR OR DAMAGE IS PRESENT.
* BLOCK MUST BE FIXED RIGID TO THE RIG
USING MOUNTING HOLES PROVIDED.
* CABLE MUST BE REAVED OR OTHERWISE RIGGED SUCH
THAT CABLE IS IN LINE WITH BLOCK ENTRY/EXIT
PORTS. DO NOT ALLOW CABLE TO RUB AGAINST
MEMBERS ON RIG.
* THIS SYSTEM IS DESIGNED TO BE USED WITH 1/4 INCH DIA.
7 X 19 WIRE ROPE. INSTALLATION REQUIRES 1 1/2 WRAPS
OF CABLE ON THE DRUM.