ACR Electronics OLAS CORE User manual

0438
0347
1152
0438
Near
1152
Near
0347
Near
MOB
1. Connect the OLAS app to the Core. For more
information on how to do this please refer to the Core Setup
Instructions.
Testing the alarm
2. Ensure all OLAS transmitters are seen on the OLAS app
homescreen.
3. Switch off the OLAS transmitters.
OLAS tag: press the button for 4 seconds, until a red flash is
seen. OLAS Float-On: press the button for 4 seconds until the bi-
color LED flashes red.
4. The alarm will occur after your set ‘Alert Time’
The default Alert Time is 3 seconds.
5. Press the control switch on the Core once or tap "Continue to
Recovery" in the App. This puts the system into pause state.
6. Press the control switch again once. 3 beeps will sound
to indicate that the transmitter is still missing, and the
system is still in pause state.
Press and hold the MOB button
on your GPS Chart Plotter
Send a MOB DSC alert
using your VHF
Tom
Overboard!
Step 1
Step 2
Continue to recovery
Press and hold the MOB button
on your GPS Chart Plotter
Send a MOB DSC alert
using your VHF
Tom
Overboard!
Step 1
Step 2
Continue to recovery
OR
MOB
www.acrolas.com

Testing the alarm
7. Switch the OLAS transmitter back ON. 8. Place the transmitter next to the Core.
9. Press the control switch once. Wait 10 seconds and the
system will be operating again. Solid red on the control switch
indicates it is tracking correctly.
Press for 4
seconds until
light green
10s
www.acrolas.com