ACR Electronics OLAS GUARDIAN User manual

0438
0347
1152
0438
Near
1152
Near
0347
Near
MOB
1. Connect the OLAS app to the Guardian. For more
information on how to do this please refer to the
Guardian Setup Instructions.
Testing the alarm
2. Ensure all OLAS transmitters are seen on the OLAS app
homescreen.
3. Switch off the OLAS transmitters.
OLAS tag: press the button for 4 seconds, until a red flash
is seen. OLAS Float-On: press the button for 4 seconds
until the bicolor LED flashes red.
4. The alarm will occur after your set ‘Alert Time’ and the
engine will cut out. The default Alert Time is 2 seconds.
5. Press the Guardian’s control switch once or tap
"Continue to Recovery" in the App. This puts the system
into pause state.
6. Press the control switch again once. 3 beeps will sound
to indicate that the transmitter is still missing, and the
system is still in pause state.
Press and hold the MOB button
on your GPS Chart Plotter
Send a MOB DSC alert
using your VHF
Tom
Overboard!
Step 1
Step 2
Continue to recovery
Press and hold the MOB button
on your GPS Chart Plotter
Send a MOB DSC alert
using your VHF
Tom
Overboard!
Step 1
Step 2
Continue to recovery
OR
MOB
www.acrolas.com

Testing the alarm
7. Switch the OLAS transmitter back ON. 8. Place the transmitter next to the Guardian.
9. Press the control switch once. Wait 10 seconds and the
system will be operating again. Solid green on the
control switch indicates it is tracking correctly.
Press for 4
seconds until
light green
10s
www.acrolas.comwww.acrolas.comwww.acrolas.com