Addonics Technologies M2MSHD9H-2S User manual

CONTACT US
Technical Support
If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: [phone]
Email: http://www.addonics.com/support/query/
www.addonics.com
Phone: [phone]
Fax: [phone]
Email: http://www.addonics.com/sales/query/
1:9 M2/mSATA /SSD/HDD
Duplicator PRO
Model: M2MSHD9H-2S
Default settings on the duplicator:
Copy – set to WHOLE MEDIA. This setting copies everything in the source
drive to the target drive sector by sector. This setting ensures a good copy of
any drives: boot drive, blank drive, encrypted drive or drive with any file
system.
To speed up the copying, you may change the setting to SYSTEM and FILES.
This setting skips copying sectors with no recognizable data. This is only for
drives that have the following file system: NTFS, FAT/16/32, eXFAT, HFS,
EXT3/4 or XFS. This setting is not recommended for copying boot drive as
certain boot sectors may not be copied correctly.
Performance – set to SPEED for best performance. May encounter
compatibility issue with certain SSD or old HDD. Should that occur, try to
change the setting to BALANCE or COMPATIBILITY.
Please review the High-Speed Duplicator Controller User Manual for all the
detail settings.
Making duplicates
Power up the unit by pressing on the ON/OFF button at the front lower right-
hand corner. Once the unit is ready, the LCD should display
HDD Duplicator
1. Copy
The unit is now ready. Load a source drive to the source slot (the top bay for
3.5” HDD or the first vertical bay on the lower left for 2.5” HDD/SSD). Be sure
the source switch at the back is set correctly. Load the target drives to the
target slots (the lower nine vertical bays from the right). After a few seconds,
the LCD should display the number of target drives detected. Press the OK
button on the LCM control panel to start the copying.
Note: some drives may not be detected correctly. In that case, please leave the
drive inside the unit and re-start the duplicator.

www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email. www. Addonics.com/support/query/
Overview Rear view
M2 SSD installation mSATA SSD installation
WARNING
Be sure to set the 110/240V
switch to the correct setting
to your local outlet before
powering on the unit. Wrong
setting may cause damage
to the power supply
Package content:
•1:9 M2/mSATA /SSD/HDD Duplicator PRO main unit
•Ten (10) units of 2.5” M2/mSATA flash drive adapter (model: AD25M2MSA)
•One power cord
•One 6-in eSATA cable (use for source selection)
•This quick start user guide
•High-Speed Duplicator Controller User Manual