TSU ACE P/N 1200295L1
For more detailed documentation, visit us online at www.adtran.com
Quick Start Guide, 61200295L1-13A, September 2001 Technical Support 1-888-4ADTRAN (1-888-423-8726) Copyright 2001 ADTRAN, All Rights Reserved
NETWORK CONNECTION PINOUT
Pin Name Description
1 R1 RXDATA Receive data from the Network - Ring
2 T1 RXDATA Receive data from the Network - Tip
3, 6, 7, 8 UNUSED n/a
4 R TXDATA Transmit data towards the Network - Ring
5 T TXDATA Transmit data towards the Network - Tip
Network T1
NETWORK
V.35 NX56/64
OFF ON
NETWORK
115VAC/60HZ
.15A
INSTALLATION INFORMATION
• An eight-position modular jack (labeled NETWORK) is provided to
connect to the network T1 circuit. The pinout is provided on this Quick
Start Guide. See
Chapter 2, Installation,
of the TSU ACE User Manual
for more information.
•The rear panel contains a single V.35 interface for connecting to DTE
equipment. The pinout for this interface is located in
Appendix C
of the
TSU ACE User Manual.
•When shipped from the factory, the TSU ACE is uninitialized and set to
factory default conditions. At the first application of power, the unit will
automatically execute self-tests followed by an initialization sequence.
•The TSU ACE can be configured and controlled using the local front
panel of the unit or from ADTRAN’s PC Control Program, T-WATCH. A
limited menu tree is provided on the back of this sheet. For more
detailed menu information, refer to the TSU User Manual.
•Additional information can be found on the product CD which contains
the TSU ACE User Manual, FAQs, Data Sheets, Applications, and
White Papers.
REAR PANEL DESCRIPTIONS
Network Connector Connection to T1 circuit
V.35 Connector High-speed DTE interface
Power Switch Turns power to the TSU on or off
115 VAC Connection Power cord connection for a reliably grounded
115 VAC, 60 Hz power source
