ADTRAN SMART/RG SR506n User manual

SR506n
Quick Start Guide

Installation
For DSL connections, connect one end of the supplied DSL cable to the
DSL port on the gateway and the other end to the DSL wall jack
installed by your provider.
For all other devices, connect an Ethernet cable from the device to
any of the LAN ports on the gateway.
Connect the power adapter to a wall outlet and to the Power port on
the gateway. For additional protection, connect the power cord to a
surge protector. Press the ON/OFF button on the gateway to turn it
on.
Your gateway is setting up to connect to the Internet. This process may take a
few minutes. If you are unable to connect to the Internet, verify that all cable
connections are in place and that the gateway’s power is turned on.

3
1 2 3

LED Indicators
The LEDs on the SR506n can help you
understand the current state of your gateway.
LED Action Meaning
Power Connected
DSL Connected
Syncing
Internet Connected
Authentication failed
LAN4 – LAN1 Connected
Data is being transferred
USB Connected

Logging in to Your Gateway
To change the settings on your gateway, you must log in to the gateway's
interface. Make sure that you have completed the steps in "INSTALLATION"
before you begin.
Open your Internet browser application, type 192.168.1.1 into the address
line and press Enter. The Login dialog box appears.
5

Enter the username and password and click OK. The default credentials
are admin and admin.
Note: Your service provider may use other settings. Please contact your
provider for login information.
The Device Info summary page appears.
Configuring the WAN Manually
If the automatic connection process is unsuccessful, refer to the Advanced
Setup > Layer 2 Interface and WAN Services sections of the Gateway User
Manual to manually establish a connection.

WiFi Setup
Two methods, WPS and Manual, are available for WiFi setup.
Perform the steps on this page for both methods, and then follow the
instructions for the method you desire.
In the left navigation bar, click Wireless. The Wireless > Basic page
appears. Wireless is enabled by default.
7

If desired, in the SSID field, enter the network name to which you
want your client devices connected.
Continue with the steps in the method you prefer.

WPS Method
If the device you wish to connect to the Internet via your SmartRG gateway
supports the WPS secure WiFi connection method, you may follow these steps.
1. In the left menu, click Wireless >Security.
2. In the Enable WPS field, select Enabled and click Apply/Save.
3. On the top of the gateway, press the button labeled WPS.
4. Within 2 minutes, activate WPS on the 3rd party device to which you
wish to connect. It may have a pushbutton on its exterior or a software
interface where you can initiate WPS connection. To learn how to use
the WPS feature on your client device, refer to its documentation.
Your device should now be connected to your router wirelessly using WPS. If
you encounter problems with the WPS setup such as connection failure, refer
to your client device for further instructions.
9

Manual Method
Set up your gateway’s parameters first, then:
1. In the left menu, select Wireless >Security and scroll down to the
Manual Setup AP section.
2. Select the SSID of the network you wish to configure. You will need this
ID for step 7.
3. Select the desired Network Authentication. Make sure that the host
devices you intend to use support the selected authentication type.
4. Choose a WPA passphrase and type it in this field. You will need this
passphrase for step 7.
5. Select any desired encryption preferences in the lower three fields.
6. Click Apply / Save.
7. Follow the WiFi connection instructions provided with your client device
to connect to the router. Use the SSID name you selected in Step 2.
Then, in the network setup screen of your WiFi client device, enter the
Passphrase that you entered in step 4 above.