Advantech ADAM-3750 3-Wire Series Installation and operation manual

1 ADAM-375 3-Wire Series Startup Manual
ADAM-3750 3-Wire Series DIO Slave Modules
Startup Manual
• DIN rail mounting (L-124 x W-72 x H-53 mm)
• Max. 20 Mbps transfer rate
• 3-Wire terminal board for actuator/sensor
• Easy installation with RJ45 phone jack and LED diag-
nostic
• Serial interface: half duplex RS-485 with transformer iso-
lation
• Cable Type: CAT5 UTP/STP Ethernet cable
• Surge Protection: 10 kV
• Transmission Speed: 2.5 Mbps, 5 Mbps, 10 Mbps and
20 Mbps
• On-line module insertion and removal
• IO Isolation Voltage: 2.5 kVrms
• Input Impedance: 2.4 KΩ/ 0.5 W
• Input Current: ±10mA(Max)
• Output Types: NPN/PNP open collector Darlington tran-
sistors
• Switch Capacity: each output channel is 60 mA at 24
VDC
• Response Time: On to Off, about 180 µs; Off to On,
about 1.2 µs
• Power Supply: +18 VDC to +30 VDC
Consumption: 3 W typical
• Working Temperature: 0 to 60° C
Features Specifications
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
http://www.advantech.com/eAutomation
For technical support and service, please visit our
support website at:
http://service.advantech.com.tw/eservice/
This manual is for ADAM-3750 3-Wire Series.
Part No. 2003000800 1st Edition
August 2004
ADAM-3750 3-Wire Series DIO Slave Modules

2 ADAM-375 3-Wire Series Startup Manual
Communication Connector (RJ45)
External Power Input Connector
ID Setting DIP Switch
Note:
Node Number=32xA5+16xA4+8xA3+4xA2+2xA1+A0
Configuration Setting
Note: TD and BK are reserved
Note: default system clock = 80 MHz
Common Connector Pin Definitions
Pin Label Description
1NC FG
2NC FG
3 RS485+ RS485+
4NC FG
5NC FG
6 RS485- RS485-
7NC FG
8NC FG
Pin Label Description
1 24V DC 24V
2 GND DC 24V Ground
3 FG Field Ground
4 24V DC 24V
5 GND DC 24V Ground
6 FG Field Ground
Switch Label ON OFF
1A5 1 0
2A4 1 0
3A3 1 0
4A2 1 0
5A1 1 0
6A0 1 0
Switch Label Description ON OFF
1 B1 *Baud-Rate Setting 1 0
2B0 10
3 *TD Time-Out Status Latch Enable Disable
4 TM Watchdog Mode Enable Enable
5 *BK Break & Rescan Commu-
nication
Enable Disable
6 TR Terminate Resistance Enable Disable
B0 B1 Baud-Rate Setting
OFF OFF 1/4 System Clock
OFF ON 1/8 System Clock
ON OFF 1/16 System Clock
ON ON 1/32 System Clock

ADAM-375 3-Wire Series Startup Manual 3
Specific Connector Pin Definitions
ADAM-3752
Pin Label Pin Label
1 IN_00 19 IN_20
2 IN_01 20 IN_21
3 IN_02 21 IN_22
4 IN_03 22 IN_23
5 IN_04 23 IN_24
6 IN_05 24 IN_25
7 IN_06 25 IN_26
8 IN_07 26 IN_27
9GND 27GND
10 GND 28 GND
11 IN_10 29 IN_30
12 IN_11 30 IN_31
13 IN_12 31 IN_32
14 IN_13 32 IN_33
15 IN_14 33 IN_34
16 IN_15 34 IN_35
17 IN_16 35 IN_36
18 IN_17 36 IN_37
ADAM-3758
Pin Label Pin Label
1 IN_00 19 IN_20
2 IN_01 20 IN_21
3 IN_02 21 IN_22
4 IN_03 22 IN_23
5 IN_04 23 IN_24
6 IN_05 24 IN_25
7 IN_06 25 IN_26
8 IN_07 26 IN_27
9GND 27GND
10 GND 28 GND
11 IN_10 29 OUT_30
12 IN_11 30 OUT_31
13 IN_12 31 OUT_32
14 IN_13 32 OUT_33
15 IN_14 33 OUT_34
16 IN_15 34 OUT_35
17 IN_16 35 OUT_36
18 IN_17 36 OUT_37
ADAM-3756
Pin Label Pin Label
1 IN_00 19 OUT_20
2 IN_01 20 OUT_21
3 IN_02 21 OUT_22
4 IN_03 22 OUT_23
5 IN_04 23 OUT_24
6 IN_05 24 OUT_25
7 IN_06 25 OUT_26
8 IN_07 26 OUT_27
9GND 27GND
10 GND 28 GND
11 IN_10 29 OUT_30
12 IN_11 30 OUT_31
13 IN_12 31 OUT_32
14 IN_13 32 OUT_33
15 IN_14 33 OUT_34
16 IN_15 34 OUT_35
17 IN_16 35 OUT_36
18 IN_17 36 OUT_37
ADAM-3754
Pin Label Pin Label
1 OUT_00 19 OUT_20
2 OUT_01 20 OUT_21
3 OUT_02 21 OUT_22
4 OUT_03 22 OUT_23
5 OUT_04 23 OUT_24
6 OUT_05 24 OUT_25
7 OUT_06 25 OUT_26
8 OUT_07 26 OUT_27
9GND 27GND
10 GND 28 GND
11 OUT_10 29 OUT_30
12 OUT_11 30 OUT_31
13 OUT_12 31 OUT_32
14 OUT_13 32 OUT_33
15 OUT_14 33 OUT_34
16 OUT_15 34 OUT_35
17 OUT_16 35 OUT_36
18 OUT_17 36 OUT_37