Aiphone LEF-LD User manual

Note:
The jumper between E & -
must remain attached on the
master station.
- INSTRUCTIONS -
The LEF-LD system is designed with the capability to operate at greater distances and for use in
elevators. The sub stations are available in either surface or flush mount styles. Any LEF, LAF-C/CA, or
LDF master can be modified for Long Distance. This is a SINGLE MASTER SYSTEM ONLY. EXTERNAL
SIGNALING WITH THE RY-AC/A RELAY IS NOT SUPPORTED ON THIS SYSTEM.
WIRING DIAGRAMS:
LEF Loudspeaker Intercom System for Long Distance and Elevator Applications
LEF-3-LD, LEF-3L-LD, LEF-5-LD, LEF-10-LD, LEF-10S-LD
LEF-3C-LD, LEF-5C-LD, LEF-10C-LD
IF-DA-LD
1
2
Wht
-
+
PS-1225UL
LEF Master Terminal Definitions:
1~10 Selective call/communication
terminal for each call button
E Common communication
+ 12V DC
- Negative, common call signal
IF-DA-LD Sub Terminal Definitions:
1 Call-in and Communication
2 Common
White +12V DC (connect to + of PS-1225UL)
LEF-5-LD
Method A:
3 conductors homerun
from master to each sub. 1
2
3
~
5
E
-
+
IE-JA-LD
1
2
3
Wiring Distance: 22 AWG = 2000'; 18 AWG = 4000'
Use Aiphone #822202 or #821802 wire.
IMPORTANT:
Only the IF-DA-LD, IE-JA-LD, IE-SS-LD and IE-SSR-LD will function with these “LD” type master stations. Standard
LE- or LS-series sub stations cannot be used with LEF-LD master stations. In addition, the remote stations listed
above will only function with the "LEF-LD, LAF-LD or LDF-LD" model master stations.
NOTE: “C” terminal of the
master station is not used
in this system.
IE-JA-LD Mounting:IF-DA-LD Mounting:
TORX
screws
IE-JA-LD Sub Terminal Definitions:
1 Call-in and Communication
2 Common
3 +12V DC (connect to + of PS-1225UL)
IE-SS(R)-LD Sub Wire Definitions:
Red Call-in and Communication
Black Common
White +12V DC (connect to + or PS-1225UL)
IE-SS(R)-LD
Red
Blk
Wht
Pg. 1
IE-SS(R)-LD Mounting:
Installation Examples:

Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
[phone]
FAX [phone]
Page. 2
LEF-LD Instr.
0207JD
TOLL FREE TECHNICAL SUPPORT:
[phone]
TOLL FREE FAX LINE:
[phone]
E-mail: [e-mail]
NOTE:
Only wiring concerning the LEF-LD is shown here. For additional installation information
(door release wiring, operation, mounting), please refer to the standard LEF instructions.
This is a SINGLE MASTER system only.
IE-SS(R)-LD
Red
Blk
Wht
-*
+
PS-1225UL
E/- jumper
attached on
master
LEF-10-LD
1
2
~
10
E
-
+
1
2
3
Method B:
2 conductors homerun from master to each sub.
12V DC power provided at each sub station location.
IE-JA-LD
*-
+
12V DC
Power
* Negatives of all power
supplies are common.
-*
+
12V DC
WIRING DIAGRAMS (continued):
OPERATION:
1. Pressing the call button at the remote station will activate the call tone, plus light the
appropriate station LED at the LEF-LD master. The call tone will be momentary as long as
the call button is held down, and the LED light will stay on for approximately 20 seconds.
2. To answer the call at the LEF-LD master, press the station button corresponding to the lit
LED, then press TALK to speak to the caller.
3. Communication at the master station is "press-to-talk, release-to-listen". Communication
at the door station is hands free.
4. (If selective door release is included): With communication established to the door station,
pressing the door release button will activate the door release mechanism at the
corresponding door.
5. When the call is completed, press OFF on the LEF-LD master station. This puts the
system in standby mode.
12V DC
Power