Air Packaging Machine HP50-D2 User manual

Instructions of electric
honeycomb paper machine
MODEL：HP50-D2
VERSION：202106
www.AirPackagingMachine.com

CONTENTS
2
2
3
4
5
5
-1-
SAFETY PRECAUTIONS
BASIC PARAMETERS OF EQUIPMENT
STRUCTURE INTRODUCTIONS
KEY OPERATION INSTRUCTIONS
INSTALL INSTRUCTIONS
INSTRUCTIONS FOR USE
www.AirPackagingMachine.com

100-230V 50/60HZ 40W 35CM/S 23KG 73*42*35CM
-2-
Voltage Power Speed Weight Size
Please use 100-230V power supply.
Avoid placing in direct sunlight and outdoors.
Please cut off the power quickly when break down.
Please disconnect the power supply and remove the plug , when cleaning or
repairing equipment.
Do not disassemble or repair equipment without the knowledge of engineer.
SAFETY PRECAUTIONS
BASIC PARAMETERS OF EQUIPMENT
www.AirPackagingMachine.com

Resistance adjustment handle
Paper enter handle
Speed control knob
Automatic mode and timing mode
Start-stop switch
Timer mode loop button
Timer
White liner paper roller
Pedal
-3-
STRUCTURE INTRODUCTIONS
Paper exit place
Honeycomb paper roller
Power supply
Resistance adjustment handle
www.AirPackagingMachine.com

Adjust the paper output speed.
Automatic mode: continuous output mode. Press the
square button to start continuous output, and then
press again to pause.
Timing mode: the paper will output during the setting time.
The switch which is control start and stop of automatic
mode and timing mode.
When the set time is stopped, it can be activated
again to cycle.
Set the paper output time between 0-30s.
Slightly step on the pedal to output the paper, release
pedal to stop paper output.
-4-
KEY OPERATION INSTRUCTIONS
SPEED CONTROL KNOB
AUTOMATIC MODE AND TIMING MODE
START-STOP SWITCH
TIMER MODE LOOP BUTTON
TIMER
PEDAL
www.AirPackagingMachine.com

Take out the whole machine and install the support plate (pay attention to distinguish
the left and right directions).
As shown in Figure 1, insert the paper roller (note the direction of the honeycomb paper).
As shown in Figure 2, put on the paper (pay attention to the direction of the honeycomb
paper, honeycomb paper need put in front of white lining paper).
-5-
操作说明
2
12
INSTALL INSTRUCTIONS
INSTRUCTIONS FOR USE
1
www.AirPackagingMachine.com

Open the paper enter handle
Turn the paper enter handle counterclockwise to make the honeycomb paper pass
through the device.
Pull the handle outwards, and fold the handle inward.
-6-
1 2
12
2
13
www.AirPackagingMachine.com

When the honeycomb paper does not stretch out shape of honeycomb holes, the adjustment
handles on both sides can be adjusted at the same time to increase the resistance and
adjust to a suitable state.
Press the start-stop switch, select automatic mode, fine-tune the speed adjustment knob to
make the honeycomb paper come out of the paper outlet, and then pull out a section of the
white liner paper and place it on the honeycomb paper so that the white liner paper comes
out of the paper outlet channel.
-7-
www.AirPackagingMachine.com