Allegion FALCON LM Series User manual

R
R
R
L
L
R
R
R
L
L
R
R
L
L
R
R
L
L
R
R
L
L
R
R
L
L
R
R
L
L
R
R
L
L
1. Holding lever as shown,
bend tab of lockwasher back
flat. Remove nut.
2. Holding lever securely, rotate
rose assembly clockwise
slightly, and remove plate and
lockwasher.
3. Using caution, allow rose
assembly to rotate counter-
clockwise to relieve spring
tension.
4. Remove spring and reinstall
with spring hook on opposite
side of post.
5. Holding lever securely,
rotate rose assembly
counterclockwise slightly
past 90 deg.
6. Reinstall plate with "L" side
up and in line with "L" on
rose assembly.
7. Reinstall lockwasher and nut.
Tighten nut and then back off
slightly until rose assembly
rotates freely under plate.
Bend up one tab of
lockwasher against nut.
RE-HANDING INSTRUCTIONS FOR LM SERIES LOCK TRIM
Example shown is a right hand being changed to a left hand
Reverse sequence to change from left to right hand
Note: Inside trim is always opposite the outside trim LH/LHR RH/RHR
VIEWED FROM OUTSIDE
L
© Allegion 2014 Printed in U.S.A. 030253-000-70 Rev. 10/14-d

Additional Notes: Revision History Revision Description:
D > Revised artwork
1. None A B C D E F
5440 0790 6683
Material
White Paper
Edited By Approved By EC Number Release Date
J. Ellis M. Roberts xxxxx 10/14
Notes
1. printed one side
2. printed black
3. tolerance ± .13
4. printed in country may vary
Title
Rehanding Instructions, LM Series Lock Trim
Creation Date
10-22-14
Number
030253-000-70
Revision
D
Created By
J. Ellis Activity
3899 Hancock Expwy
Security, CO 80911 © Allegion 2014Software: InDesign CS6
8.500
5.500
BEGINNING SHEET
FRONT