Allegion FALCON X571 User manual

SPECIAL INSTRUCTIONS FOR
X571 LOCK
WITH INTERCHANGEABLE CORE
TO CORRECT OUT OF TIME CONDITION
BUTTON DOES NOT OPERATE...
OR KEY WILL NOT ROTATE CLOCKWISE...
THEN THE DOGGING BAR IS OUT OF "TIMING"
TO CORRECT—
1. TAKE OFF INNER KNOB AND ROSE,
AND REMOVE LOCK FROM DOOR.
2. ON OUTSIDE KNOB REMOVE CORE, BACK OFF
TAILPIECE ASS'Y UNTIL IT DISENGAGES FROM
KNOB CATCH.
3. PLACE DOGGING BAR IN POSITION AS
ILLUSTRATED BELOW. LOCK OUTER TRIM
BY PUSHING IN PUSH BUTTON.
4. ENGAGE TAILPIECE ASSEMBLY AND INSERT CORE.
5. RE-INSTALL LOCK ON DOOR.
INNER SPINDLE
OUTER SPINDLE
CORRECT POSITION OF DOGGING BAR.
NOTCH IN DOGGING BAR MUST POINT DOWN INTO LOCK.
DOOR CENTER

SPECIAL INSTRUCTIONS FOR X571 LOCK
TO CORRECT OUT OF TIME CONDITION
BUTTON DOES NOT OPERATE...
OR KEY WILL NOT ROTATE CLOCKWISE...
THEN THE DOGGING BAR IS OUT OF "TIMING"
CARE MUST BE TAKEN NOT TO ROTATE EITHER
KNOB SPINDLE WHEN CYLINDER HAS BEEN REMOVED.
TO CORRECT—
1. TAKE OFF INNER KNOB AND ROSE,
AND REMOVE LOCK FROM DOOR.
2. REMOVE OUTSIDE KNOB AND CYLINDER
ASSEMBLY.
3. PLACE DOGGING BAR IN POSITION AS
ILLUSTRATED BELOW.
4. LOCK MUST BE IN THE UNLOCKED POSITION
BEFORE KNOB IS INSTALLED.
5. REPLACE OUTER KNOB AND CYLINDER ASSEMBLY
PER INSTRUCTIONS PACKAGED WITH LOCK.
6. INSTALL LOCK ON DOOR.
INNER SPINDLE OUTER SPINDLE
CORRECT POSITION OF
NOTCH IN DOGGING BAR
DOOR CENTER
©2015 Allegion
Printed in U.S.A
002376-000-70 Rev. 05/15-d