Allegion Legge 990MF User manual

Right Hand
OPENING IN
OPENING OUT
Outside Outside
Left Hand
OPENING OUT
OPENING IN
990MF Handing/Function Adjustment
V Series handing adjustment (Inside handle free)
To set for left hand
Push in and turn clockwise. Set adjuster as shown.
To set for right hand
Push in and turn anti-clockwise. Set adjuster as
shown.
V9/V10/V55/V56
The Locking Bar must be down before installing.
D & S Series Deadlocks & Sliding door locks
Set adjuster as shown.
To set for C Series (Both handles lockable)
Supplied unhanded. Fit cylinder or turn adaptor to
appropriate sides. When only one cylinder or turn is
used fit plug into unused hole.
V SERIES
LH
FREE
LOCKABLE
V SERIES
RH
FREE
LOCKABLE
C SERIES
LOCKABLE
Handing/Function
Adjuster
1.
To Reverse Bolt
2.
Remove outer forend.
Handing Guide
Pull & rotate bolt through 180° clockwise.
Allegion (New Zealand) Limited
Phone [phone]
Website www.allegion.co.nz 12/2013
Allegion (Australia) Pty Ltd
Phone [phone]
Website www.allegion.com.au
990MF Mortice Lock
Installation Instructions

DEPTH OF MORTICE IS 92MM FOR 60MM BACKSETDEPTH OF MORTICE IS 92MM FOR 60MM BACKSET
Centre of lock
ALL FUNCTIONS EXCEPT NIGHT TURN WITH EMERGENCY
LATCH OR EMERGENCY RELEASE RELEASE(N SERIES)
NIGHT LATCHES
To suit furniture
Edge of bolt
1. Mortice Instructions 2.
Cut mortice slot using template for correct size.
3.
Fit lock into mortice, scribe around forend and remove
wood to allow flush fit to door.
Hole 20mm Cylinder Cylinder
Hole 20mm
Remove lock and use template to mark and drill holes to suit lock and furniture being used.
TOP TOP
Turn Hole 20mm
Turn Hole 20mm
Spindle Hole 22mm
Spindle Hole 22mm
60mm Backset 70mm Backset 89mm Backset
127mm Backset
60mm Backset 70mm Backset 89mm Backset
127mm Backset
6.5mm holes for horizontal fixed rose furniture only at 41.0mm centres.
6.5mm holes for horizontal fixed rose furniture only at 41.0mm centres.
6.5mm holes for horizontal fixed rose furniture only at
38.0mm centres.
6.5mm holes for horizontal fixed rose furniture only at
38.0mm centres.
2 x 6.5mm holes for diagonal fixed rose furniture only at
50.8mm centres.
2 x 6.5mm holes for diagonal fixed rose furniture only at
50.8mm centres.
IMPORTANT
A MAXIMUM CLEARANCE OF 5mm IS RECOMMENDED BETWEEN LOCK FOREND AND STRIKER PLATE FOR SECURITY REASONS.
CHECK CAREFULLY: DO NOT DRILL HOLES RIGHT THROUGH DOOR. THE FURNITURE MAY NOT COVER
ANY HOLES THAT ARE
INCORRECTLY DRILLED.
990MF LOCKS ARE DESIGNED FOR USE WITH SPRUNG DOOR FURNITURE. THE USE OF UNSPRUNG DOOR FURNITURE IS NOT RECOMMENDED.