Altec SIRYNX RF User manual

NOTDEM0UK000039-V1.01
QUICK START GUIDE
Range of wireless sirens 869 MHz
Made in FRANCE
SIRENS RF
This quick start guide allows quickly installing the PILOTE RF and its sirens in the factory settings.
For any other operation, please see the complete technical manual.
1- INSTALLATION
REQUESTED MOUNTING DIRECTION
SIRYNX RF SIRUS RF PILOTE RF
2- CONNECTION OF THE SIRENS BATTERIES
Connect imperatively two batteries to the electronic card to ensure the autonomy of the
SIRYNX RF and of the SIRUS RF.
3- DESCRIPTION OF THE CONNECTION TERMINAL OF THE PILOTE RF
0V
DC
Charge +12V
The power 12V continues to be supplied by an uninterruptible power supply
with limited power.
1 Output for supervision failure (by default = 0V)
2 Output for the failure of sirens low battery (by default = 0V)
OUTPUTS
3 Output for the failure of the PILOTE RF batteries (default = 0V)
CMD Input of command configurable
Factory settings : Information Arm/Disarm
Alarm by disappear of 12V
INPUTS
BL.SIR Input of sirens blocking configurable
Factory settings : Triggering of all the sirens
Alarm by disappear of 12V
A.P. TAMPER Tamper protection
TOP TOP TOP
CAUTION
MANDATORY
Get the wires to
the bottom of
the housing
SIRYNX RF
BATTERIES
CONNECTORS
SIRUS RF
BATTERIES
CONNECTORS

4- ADD A SIREN
To add a new siren on the PILOTE_RF, following the procedure:
1 Supply the
PILOTE RF
2 Connect the two
sirens batteries
3 Push VALID
4 Remove the
cover
5 Push VALID Waiting phase
pushing the siren
button.
6 Push the siren
button
The siren flashes
and beeps
7 10 seconds or
VALID
Waiting phase
new siren
8 If there is no
more sirens to
add, push
VALID
The PILOTE RF
displays the
quantity of outdoor
sirens
9 Push VALID The PILOTE RF
displays the
quantity of indoor
sirens
10 Push one of the
buttons
The PILOTE RF
goes back to the
general
programming
11 Close the sirens
covers and the
PILOTE RF to
exit the
programming
12 The system is
ready for
operation
5- SIRENS TEST
To test a siren of the installation, following the procedure:
1 Enter in
programming of
the control panel
and then of the
PILOTE RF
2 Push +
3 Push VALID Menu to choose
the siren that you
want to test
4 Push + or – to
select the siren
that you want
to test and
then VALID
The siren sounds
during 3 seconds
during the
waiting phase
5 10 seconds or
VALID
Return to the
menu of choice
6 If there is no
more siren to
test, push + & -
Return in general
programming
Remove
COVER
>ADD<
>SIREN<
X SIREN
INDOOR
X SIREN
OUTDOOR
WAIT 2mn
1 SIREN
SIR N° 01
OK
WAIT 2mn
0 SIREN
>ADD<
>SIREN<
Close
COVER
>ADD<
>SIREN<
> TEST <
>SIREN<
WAITING
SIR N°01
SIREN
N°01 ?
TEST SIR
N°01 OK
SIREN
N°01 ?
> TEST <
>SIREN<