Alto-Shaam AR-7H ELECTRONIC CONTROL User manual

AR-7H
HOT HOLDING ROTISSERIE COMPANION
D U E T O O N G O I N G P R O D U C T D E V E L O P M E N T,S P E C I F I C AT I O N S A R E S U B E C T TO C H A N G E W I T H O U T N O T I C E .P R I N T E D I N U .S.A. #52B - 06/08
ITEM NO. _______________________
●HALO HEAT... a controlled, uniform heat source that
gently surrounds foods for better appearance, taste, and
longer holding life.
●Smart styling, advanced design.
●Adjustable thermostat and temperature gauge monitor inside
air temperature.
●Solid state electronic control option simplifies temperature
setting, has a clear, easy-to-read LED display, and is adjustable
in increments of 1 degree.
●Stackable with an identical holding cabinet or matching
rotisserie oven without additional hardware.
●Solid stainless steel back prevents further heat loss.
Reach-in companion holding cabinet with 20 gauge non-magnetic stainless steel construction throughout. The cabinet is
controlled by one (1) ON/OFF power switch, one (1) adjustable thermostat, 60° to 200°F (16° to 93°C); includes one (1)
indicator light; and one (1) holding temperature gauge to monitor inside air temperature. The compartment is equipped
with four (4) 60 watt bulbs, four (4) stainless steel wire shelves, two (2) stainless steel side racks, and sixteen (16)
non-tilt pan support rails spaced at 2-15/16" (75mm) centers. Low-e glass door and magnetic latch is hinged right, with
one (1) rugged, easy-grip, curved handle. One (1) set of 5" (127mm) heavy duty casters—two (2) rigid and two (2)
swivel with brake—are included.
Electronic control includes a 4-digit LED display, ON/OFF key, up and down arrow keys for temperature adjustment,
and miscellaneous indicator lights for operational status. The control has a built-in lock out feature.
■■MODEL AR-7H: Hot Holding Rotisserie Companion with single pane flat glass, electronic control
■■MODEL AR-7H: Hot Holding Rotisserie Companion with single pane flat glass, manual control
■■MODEL AR-7H: Hot Holding Rotisserie Companion with double pane curved glass, electronic control
■■MODEL AR-7H: Hot Holding Rotisserie Companion with double pane curved glass, manual control
ANSI/NSF 4
W164 N9221 Water Street • O Box 450 • Menomonee Falls, Wisconsin 53052-0450 • U.S.A.
HONE: 262.251.3800 800.558.8744 U.S.A./CANADA FAX: [phone].329.8744 U.S.A. ONLY
www.alto-shaam.com
● Panel color choices
➥Specify color choice:
■■Stainless steel, standard
■■Black, optional
■■Burgundy, optional
■■Custom color, optional
● Reach-in compartment is standard
➥Specify pass-through design
as a special order
■■Single pane, flat glass door
■■Double pane, curved glass door
● Right-hand door swing is standard
■■Specify left-hand door as a special order
Pass-through cabinets cannot have both doors
hinged on the same side.
●Optional HACCP Documentation web-based
software provides the ability to program,
control, monitor, and store all relevant data.
●Optional HACCP with Kitchen Management
web-based software provides the ability to
program, control, monitor, and store all
relevant data.
FACTORY INSTALLED OPTIONS
ADDITIONAL FEATURES
PASS-THROUGH
OPTION SHOWN

D U E T O O N G O I N G P R O D U C T D E V E L O P M E N T, S P E C I F I C A T I O N S A R E S U B E C T T O C H A N G E W I T H O U T N O T I C E .P R I N T E D I N U .S.A.#52B - 06/08
AR-7H
HOT HOLDING ROTISSERIE COMPANION
37-1/8" (942mm)
38-1/16" (966mm)
Electrical Connection
34-1/4" (869mm)
40-5/8" (1031mm)
25-1/2" (649mm)
6-3/8" (162mm)
for 5" casters
or optional 6" legs
57-1/16" (1449mm)
C
LElectrical Connection
at base of unit
30-3/8" (722mm)
32-1/16" (814 mm)
25-1/2" (649mm)
58-11/16" (1491mm)
Pass-Through Option
88-11-/16" (2252mm)
61-3/16" (1554mm)
(w/ optional pass-through door)
D I M E N S I O N S : H x W x D
EXT ERIOR:
40-5/8" x 38-1/16" x 32-1/16" (1031mm x 966mm x 814mm)
C L E A R A N C E R E Q U I R E M E N T S
6" (152mm) left, right, and rear sides
INSTALLATION REQUIREMENTS
● Appliance must be installed level. It must not be
installed in any area where it may be affected by
steam, grease, dripping water, high temperatures,
or any other severely adverse conditions.
● In order to maintain NSF standards, models
must be sealed at bottom by NSF approved
sealant, equipped with casters, 4" (102mm) legs
for counter models, or 6" (152mm) legs
for floor models.
E L E C T R I C A L
VOLTAGE HASE CYCLE/HZ AM S kW LUG
120 1 50/60 15 1.8 NEM A 5-20P
20A, 125V PLUG
at 208 1 50/60 8.5 1.8 NEM A 6-15P
15A, 250V PLUG
at 240 1 50/60 9.5 2.3 NEMA 6-15P
15A, 250V PLUG
230 1 50/60 9.0 2.1 CEE 7/7
220-230V PLUG
PLUG, CEE 7/7 (SCHUKO)
16 AMP 250V (#701410)
P R O D U C T \ PA N C A PA C I T Y
60 lbs (27 kg)
MAXIMUM
FULL-SIZE SHEET PANS*:
Eight (8) 18" x 26" x 1" (457mm x 660mm x 25mm)
HALF-SIZE SHEET PANS*:
Up to Sixteen (16) 18" x 13" x 1" (457mm x 330mm x 25mm)
CHICKEN BOATS: Up to 24 (6 per shelf)
*WITH ADDITIONAL WIRE SHELVES
208-240V
W164 N9221 Water Street • O Box 450 • Menomonee Falls, Wisconsin 53052-0450 • U.S.A.
HONE: 262.251.3800 800.558.8744 U.S.A./CANADA FAX: [phone].329.8744 U.S.A. ONLY
www.alto-shaam.com
O P T I O N S & A C C E S S O R I E S
■■ELECTRONIC CONTROLSPECIFY ON ORDER AS REQUIRED
DOOR, DOUBLE PANE CURVED GLASS
■■WITH HANDLE 5001202
■■WITHOUT HANDLE 5001075
■■DOOR HANDLE HD-26900
(FOR SINGLE PANE GLASS DOOR ON NON-CONTROL SIDE)
■■CONTROL OPTION KIT 5000886
FOR SOFTWARE DOCUMENTATION
COMPUTER SOFTWARE
■■HACCP Documentation*
■■HACCP with Kitchen Management*
CUSTOM PANEL COLORS
■■BLACK 5001855
■■BURGUNDY 5001854
■■CUSTOM COLOR CONTACT FACTORY
LEGS
■■LEGS, 6" (152mm) ASSEMBLY 5001414
■■LEGS, 6" (152mm) ASSEMBLY, FLANGED FEET 5001761
SHELF
■■SHELF, CHROME PLATED WIRE SH-2851
■■SHELF, STAINLESS STEEL WIRE SH-24720
STAND, STAINLESS STEEL
■■WITH STORAGE SHELF FR-26550
■■OPEN (AR-7H OVER 750-S OR 6•10iNES) 5002058
37-1/8" (942mm)
38-1/16" (966mm)
Electrical Connection
34-1/4" (869mm)
40-5/8" (1031mm)
25-1/2" (649mm)
6-3/8" (162mm)
for 5" casters
or optional 6" legs
57-1/16" (1449mm)
C
LElectrical Connection
at base of unit
30-3/8" (722mm)
32-1/16" (814 mm)
25-1/2" (649mm)
58-11/16" (1491mm)
Pass-Through Option
88-11-/16" (2252mm)
61-3/16" (1554mm)
(w/ optional pass-through door)
WEIGHT
N E T: 260 lb (118 kg) S H I : 310 lb (141 kg)
CRATED DIMENSIONS (EST.): HXWXD
49" X50" X45" (1245mm x 1270mm x 1143mm)
* REFER TO HACC S ECIFICATION #9015
FOR A LICABLE ART NUMBERS.