Alula DWS-LL User manual

LongLife Door/Window Sensor is a transmitter with a
ten year battery life. Typically used to sense opening and
closings of doors and windows, it will alarm when the
magnet is pulled away from the sensor.
Features
• Industry-leading wireless range
• 10 year battery life
• Quick peel and press mounting
• Secure encrypted wireless transmissions
Enroll by placing the panel into wireless enrollment mode
and then sending an enrollment signal from the sensor.
Alternatively, the sensor can be enrolled by entering
its 8-character serial number on the interactive service
provider’s web portal.
Options for sending an Enrollment Signal
• Remove the battery tab, which can be done
without removing the cover, OR
• Remove the cover to trip tamper
Install by removing the adhesive paper and adhering the
sensor and magnet on a door or window. Make sure to
align the alignment marks on the sensor and magnet
when mounting.
High Bond Tape works great if the surface is properly
prepared and rm pressure is applied for over 10
seconds.
Surface Preparation
• Clean the surface
• Ensure the mounting surface temperature is
above 50°F
Use the panel installation guide to verify proper system setup.
LongLife Door/Window Sensor
Connect+™Encrypted (DWS-LL)
I
N
S
T
A
L
L
G
U
I
D
E
I

TRADEMARKS
Alula and Connect+ are trademarks owned by Alula Holdings, LLC.
IC NOTICE
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux cnr d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:
(1) L’appareil ne doit pas produire de brouillage, et
(2) L’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
IC: 8310A-DWSLL
Specications
FCC NOTICE
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may be received,
including interference that may cause undesired operation.
Changes or modications not expressly approved by Alula could void
the user’s authority to operate this equipment.
FCC ID: U5X-DWSLL
47-00016 • REV A • 2021-07-23
Tech Support Line • (888) 88-ALULA • [phone]
alula.com
01
Physical
Housing Dimensions
Weight with Battery
Mounting Fastener
2.90 x 1.04 x 0.39 inches (7.4 x 2.6 x 1.0 cm)
0.79 ounces (22.5 grams)
High Bond Tape
Environmental
Operating Temperature
Maximum Humidity
32 to 120°F (0 to 49°C)
85% non-condensing relative humidity
Sensor Specications
Frequency
Replacement Battery
Nominal Battery Life
Battery Voltage
Current Draw
Transmitted Indications
433.92 MHz
One Panasonic CR2032
10 years
3.0 VDC (Nominal)
20 mA (Maximum), 0.5uA (Quiescent)
Cover Tamper, Low Battery, Supervision
Certications
DWS-LL FCC, IC
Specication subject to change without notice