Alunar M505 User manual
ALUNAR M505 3D Printer Installation Guide
DϱϬϱAssembly Instructions
Attention:
1.Please make sure the package not
broken when you receive it.
2.Please check the printer parts
according to the packing list.
3. Please contract ƵƐ if any questions.
ϰ^ŬLJƉĞΘŵĂŝůĂůƵŶĂƌϯĚΛŚŽƚŵĂŝůĐŽŵ
tĞďǁǁǁĂůƵŶĂƌŶĞƚ
Name of each printer part
Assembly Step 1
Step 1
Please be aware the screw holes is in
red circles
Assembly Step 2
Step 2
Please be aware the screw
holes is in black circles
Assembly Step 3
Step 3
Assembly Step 4
Step 2
Step 3
Assembly Step 5
Assembly Step 6
Threaded rod 400mm
Assembly Step 7
Y Guide rod 380mm
Assembly Step 8
Attention：Leave vacancy between belt fixation
clamp and hot bed fixed plate for belt positioning.
Assembly Step 9
Attention: Please diagonally tighten the screws when all are in there place
Before Assembly
After Assembly
Assembly Step 9
Attention: Belt is for X&Y axis transmitting .Cut the length you
need to each transmission shaft. The belt is 1.5m in total and
10-20cm left after installation.
Assembly Step 10
Attention: Hot bed screws should be in the bottom, and
wing nuts will keep the height of hot bed level as well as
firming the hotbed.
Assembly Step 11 Attention: This hole is for Z axis guide rod positioning
Assembly Step 12
Assembly Step 13
Z axis Guide rod:380mm
Assembly Step 13
Assembly Step 14
Attention: loose the
jackscrew of elastic
coupling to place T
lead screw to the
bottom, then tighten
the jackscrew.
T lead screw 345mm
Assembly Step 15 Attention: Please keep A&B at the same level during X
rods installation. Knock the guide rods with a hammer
slightly if it’s hard to place.
X axis Guide rod 436mm
AB
Other manuals for M505
1
Table of contents
Other Alunar 3D Printer manuals
