Alva EIH502 User manual

ELECTRIC CONVECTION HEATER
WITH THREE HEAT SETTINGS
AND THERMOSTAT
ELECTRIC CONVECTION HEATER
WITH THREE HEAT SETTINGS
AND THERMOSTAT
ELECTRIC CONVECTION HEATER
WITH THREE HEAT SETTINGS
AND THERMOSTAT
EIH502
ELECTRIC QUARTZ
HEATER 1600W
A division of Stingray Accessory Manufacturers (Pty) Ltd I PO Box 30014 Tokai 7966 I [phone]
[e-mail] I www.alva.co.za TOLL- FREE NUMBER: 086 100 ALVA (2582)
Manufactured for
and distributed by
PLEASE READ THESE INSTRUCTIONS CAREFULLY
BEFORE USING THIS APPLIANCE AND RETAIN THIS MANUAL
FOR FUTURE REFERENCE.
As with all electrical applicances, certain care is required for safe use.
This heater is designed to operate safely and provide user comfort.
Failure to read and understand these instructions is dangerous and can lead to property damage,
injury, and even death.
This appliance must not be modied in any way - doing so is not legal and will make the appliance
unsafe as well as cancel your warranty.
/AlvaelectricSA
EIH502_Manual_22_12_2020_V3.indd 1EIH502_Manual_22_12_2020_V3.indd 1 2020/12/22 19:472020/12/22 19:47

• Any repairs that need to be done to the heater must be referred
to an authorized service agent only.
• DO NOT connect the appliance to multiple extension cords or
multiple outlets.
• This heater is not equipped with a device to control the room
temperature. DO NOT use this heater in small rooms when they
are occupied by persons not capable of leaving the room on
their own, unless supervised.
• This heater must not be located immediately below a socket-
outlet.
• Keep away from children.
• Some parts of this product can become very hot and cause
burns. Particular attention has to be given where children and
vulnerable people are present.
Ensure that children do not play with this heater.
This appliance is not intended or designed for use by persons (in-
cluding children) with reduced physical, sensory or mental capabili-
ties or lack of experience and knowledge, unless they are supervised
or given instruction
concerning use of this appliance by a person responsible for their
safety.
If the power supply cord is damaged, it must be replaced with a spe-
cial cord or assembly, available from the manufacturer or its service
agent.
IMPORTANT SAFETY INFORMATION
As with all appliances, misuse of this appliance or failure to fully
follow these instructions may cause re, injury or death.
Please read all the instructions before using your heater.
• Before using this appliance check that the voltage indicated on
the type plate corresponds to your mains supply voltage.
• DO NOT use this heater with a programmer, timer or any other
device that switches the heater on automatically. There is a re
risk if the heater is covered or positioned incorrectly.
• Always disconnect the heater from the electricity mains
when not in use, during installation and cleaning.
• Always ensure that the power cord is kept away from the body
of the heater. The heater body will get very hot while in use and
can melt the cable.
• Always inspect the power cord for signs of wear or damage.
If wear or damage is noted, a suitably qualied person should
replace it immediately. Failing to do so is a hazard and may
lead to re and/or electrocution/electric shock and/or property
damage and/or death.
• NEVER allow the cord to come into contact with wet or hot
surfaces or become twisted.
• DO NOT damage and DO NOT kink the power cord.
• DO NOT cover or obstruct the heater when in use.
• DO NOT insert any objects through any slot or opening in the
heater.
• Users must not disassemble the heater, or change/substitute
any parts of this heater; if the heater is faulty it is extremely
dangerous to use it.
• Keep the heater a distance of at least 1 meter from any
combustible material, such as furniture, curtains, bedding,
clothes or paper.
• Keep the heater clean. DO NOT allow objects to enter the
ventilation, as this may cause electric shock, re or damage the
heater.
• NEVER touch the appliance with wet or damp hands or feet.
• NEVER expose the appliance to atmospheric conditions (rain,
sun, etc)
• DO NOT use the appliance for anything other than its intended
use.
• DO NOT use this heater in the immediate surroundings of a
bath, a shower or a swimming pool.
Please read the
instructions carefully
before use.
Retain this manual for
future reference.
This appliance must
not be modied in
any way - doing so is
illegal and will make
the appliance unsafe
as well as void your
warranty.
It is unsafe to position
this heater where it is
close to combustible
material.
Keep combustible
materials such as
furniture, paper,
clothes and curtains
at least 1m from the
front, sides and rear of
the heater.
How to unplug your heater correctly
EIH502_Manual_22_12_2020_V3.indd 2-3EIH502_Manual_22_12_2020_V3.indd 2-3 2020/12/22 19:472020/12/22 19:47

INDEX
INDEX
WARRANTY
GENERAL INFORMATION
PARTS DIAGRAM
ASSEMBLY
USING YOUR HEATER
MAINTENANCE
TROUBLESHOOTING
TECHNICAL DATA
AFTER SALES SERVICE
2
2
3
3
4
4
5
5
5
KEY
Important information
Cautions and
warnings.
Danger
Contact an approved
ALVA technician.
Do It Yourself
WARRANTY
PLEASE RETAIN YOUR PROOF OF PURCHASE FOR
WARRANTY CLAIMS.
ALVA warrants this appliance to be free of defects in material and
quality for a period of 12 months from date of original purchase.
This warranty covers the intended use of this appliance – within
a domestic setting and not for commercial or industrial purposes.
Any damage caused by wilful abuse, tampering, modication or
unauthorized repair will not be warranted.
Please retain all packaging material, as items returned without
original packaging material may be subject to a withholding fee.
Where this appliance is found to be defective, damaged, broken,
or does not work correctly for the intended purpose, you must
return the appliance to the retailer from where it was purchased.
The warranty will only be effected with valid proof of purchase.
Failure to provide the proof of purchase will most likely result in
the repair or service required being chargeable.
If you have any questions while setting up or using this heater,
please visit www.alva.co.za or call 086 100 ALVA (2582) or e-mail
[e-mail]
GENERAL INFORMATION
Before using this heater, please read through this manual and
make sure you understand everything. If you are not sure, call
086 100 ALVA (2582) or visit www.alva.co.za for help. This
heater is a safe and efcient form of heating when used accord-
ing to these instructions.
Reading and understanding this manual should give you a good
indication of what to expect from your Alva heater.
If this product is not what you want or need, please help Alva and
the environment by not damaging or destroying any part of the
packaging, the manual or the Styrofoam inserts.
Always keep your proof of purchase. Keep these instructions for
future use. If you lose this copy, you can obtain a new copy from
your dealer or online at www.alva.co.za.
Thank you for your
purchase of this
heater. Please read
these instructions
carefully before use
and keep them in a
safe place, for future
reference.
Not using appliances
according to the
instructions is
extremely dangerous
and can lead to
property damage,
injury or death.
For indoor use only.
DO NOT use within
1m of any ammable
surfaces.
DO NOT store
ammable materials
near the heater.
2
EIH502_Manual_22_12_2020_V3.indd 4-2EIH502_Manual_22_12_2020_V3.indd 4-2 2020/12/22 19:472020/12/22 19:47

PARTS DIAGRAM
1 Heat element 1
2 Heat element 2
3 Heat element 3
4 Heat element 4
5 Convection outlet
6 Power knob
7 Cover
8 Base
ASSEMBLY
1. Open the carton and carefully remove the appliance.
2. Remove all foam and plastic seals from the edges of the
appliance.
3. Place the heater upside down on the oor so the exposed
base faces upwards.
4. Position the plastic base on heater as in Fig 1, the 4
mounting holes should align with the receiving holes on the
heater body.
5. Insert the 4 screws and secure the base to the heater body.
6. Turn the heater to the correct position and place it onto a
level horizontal surface, ensuring that the heater is in an
upright position.
The heater is now ready for use.
3
Always ensure that the
heater is unplugged
when not in use,
installing and cleaning.
5
1
2
7
8
USING YOUR HEATER
Depending on the heat setting selected, one side or both sides of
the heater will operate.
1. Insert the heater plug into the wall socket.
2. Rotate the power knob on the side of the heater to the
desired setting 1, 2, 3 or 4.
3. To switch off the heater rotate switch to "0" and remove the
heater plug from the wall socket.
NOTE: This heater is tted with a Tilt Auto Switch Off device for
your safety. if the heater tips or falls over it will automatically
switch off until placed in the upright position again.
MAINTENANCE
It is necessary to periodically wipe the heater, depending on the
placement and enviroment of its use.
Be sure the heater is fault free:
1. Check the electric mains lead is properly connected.
2. Ensure that the mains lead and plug are not damaged.
• Your heater should be checked once a year by a qualied
technician.
• If faults are suspected or detected, stop using the heater
and contact ALVA.
• Clean the exterior of your heater when required to remove
dust, using a damp cloth only.
• DO NOT use abrasive products to clean the heater;
these may damage the heater surface.
• DO NOT submerge the heater in water.
• DO NOT spray down or rinse the heater with water.
• Always make sure the heater is OFF and cool before
conducting any maintenance.
• Keep young children or inrm persons away from any hot
surfaces.
• Always disconnect the heater from the electricity mains
when not in use, during installation and cleaning.
4
OPERATION OF THE
HEATER
NOTE: It is normal when
the heater is switched on
for the rst time or when it is
switched on after having not
been used for a long period
of time, it may emit some
smell and fumes. This will
disappear when the heater
has been on a short while.
Before using the heater,
make sure you understand
the “IMPORTANT SAFETY
INFORMATION”
section of this manual.
POWER KNOB
1
2
3
4
31
24
6
Fig.1
EIH502_Manual_22_12_2020_V3.indd 3-4EIH502_Manual_22_12_2020_V3.indd 3-4 2020/12/22 19:472020/12/22 19:47

TROUBLESHOOTING
SYMPTOM CAUSE SOLUTION
Heater will not turn
ON
Not plugged in
Not switched ON
Tilt switch has
activated
Plug in and switch
on socket.
Switch ON
Stand the heater
upright on a level
surface.
5
TECHNICAL DATA
Item numbers EIH502
Voltage (V) Hz 220-240V 50-60Hz
Electric power 1600W
Insulation protection Class 1
Heating area 26m²
Dimensions 350 x 240 x 400 mm
Weight 2.8kg
AFTER SALES SERVICE
MANUFACTURED FOR AND DISTRIBUTED BY ALVA,
a division of Stingray Accessory Manufacturers (Pty) Ltd
P.O. Box 30014
Tokai, 7966
Tel: [phone]
E-mail: [e-mail]
www.alva.co.za
www.facebook.com/Alvaelectricsa
TOLL FREE NUMBER 086 100 ALVA (2582)
EIH502_Manual_22_12_2020_V3.indd 5EIH502_Manual_22_12_2020_V3.indd 5 2020/12/22 19:472020/12/22 19:47