Amantii Symmetry 3.0 Series Assembly instructions

Repair Guide for
Symmetry 3.0 Series
Revision1 02.15.21AC

Content
•Replacing the LED lights
•Replacing the flicker motor
•Replacing the heater
•Replacing the circuit board
•Replacing the signal receiver
•Replacing the canopy light
•Replacing the touch panel
•Replacing the Wi-Fi card

Replacing the LED tray lights
Step 1 To remove the trim, remove the screws circled in red.

Magnetic stone
Trim
Note that there are magnetic stones securing the bottom of the trim to the fireplace

Step 2 After the trim is removed, remove the front glass panel
Front glass panel

Step 3
Remove the steel panels holding the glass tray by removing the screws circled in red
The steel panels

Step 4
To remove the tray glass panel, lift one end upwards. The tray lights are below
the glass panel.

Step 5
Replacing the failed LED strip with a new one requires removing the screws and
unplugging the buckle
Unscrew
Unplug

Replace Flame LED light
You arrive here after following Step 1 to 4 in Replacing the LED Tray Lights.
Step 1 Once the screws circled in red are unfastened, remove the steel bar
fixing the back glass and remove the glass

Zoomed View Zoomed View
Step 2
Simply undo the screws circled in red to
remove the flame stencil

Horizontal view
Flame LED strips are attached to the back of the flame stencil

HOOK
BUCKLE
Disconnect the LED strip from the hook and unplug the buckle to replace
the LED strip
Step 3

Replacing the flicker motor
You arrive here after following Step 1 to 4 in Replacing the LED Tray Lights.
Step 1 The steel bar fixing the back glass must be removed by unscrewing
the screws circled in red. The back glass can then be removed

Zoomed View Zoomed View
Step 2
.
Simply undo the screws circled in red to
remove the flame stencil

On the left side is the flame motor that appears after the flame stencil has
been removed

Step 3
Remove the screw Disconnect the
motor from the rod
Remove the screws
to take off the motor

Step 4
Remove the screws circled in red.

Step 5
Remove the inner top panel by removing the screws circled in red

Step 6
A new flame motor can be replaced by unbuckling the flame motor
from the circuit board
INNER TOP
PANEL

Replace the heating element
You arrive here after following Step 1 to 4 in Replacing the LED Tray Lights
Step 1 Once the steel bar supporting the back glass has been removed,
remove the screws circled in red and remove the glass from its
mounting.