Amantii E 50 Installation and maintenance instructions

Fix your Fireplace
E50 E70

Contents
•How to replace LED light
•How to replace flicker motor
•How to replace the heating element
•How to replace the PCB board
•How to replace the signal receiver
•How to replace the canopy light

Replace LED light
for ember bed
Take off the Top cover from the fireplace.
STEP 1

Unscrew two screws on each side to remove 2 connecting metal pieces
STEP 2
metal piece

After 2 connecting metal pieces are removed, you can take the inner body
NOTE: 2 people are needed to hold the outer body in case the parts fall
apart and hurt people.
STEP 3

Unscrew 2 screws and take off the
front glass panel.
STEP 4

LEFT RIGHT
Unscrew 1 screw on each side to take off the metal pieces fixing ember bed glass
STEP 5

Insert the ember bed glass fixing metal piece into the gap between ember bed
glass and the front ember bed glass holder, and then hock it upwards to take
off the ember bed glass panel.
GAP
STEP 6

STEP 7
LED light for
ember bed
Unscrew the screws to replace the LED ligh.

Step 1
Take off the Top cover from the fireplace.
Replace LED light
for flame light