Amantii TRU VIEW Series Assembly instructions

TRU VIEW SERIES
TRV BESPOKE REPAIR GUIDE

SAFETY FIRST
TO AVOID ANY ELECTRICAL SHOCK OR POTENTIAL
DAMAGE TO THE UNIT REMEMBER TO TURN THE
POWER OFF TO THE UNIT BEFORE ATTEMPTING TO
REMOVE OR INSTALL ANY PARTS.

Table of Content
•Replacing the canopy LED strip
•Replacing the flame LED strip
•Replacing the motor
• Replacing the ember bed LED strip
•Replacing the WiFi PCB
•Replacing the heating element
•Replacing the PCB Board
•Replacing the AC adapter
•Replacing the bluetooth speaker set
•Replacing the speaker set
• Replacing the touch panel circuit board

REPLACING THE CANOPY LED STRIP
Remove the 3 screws ( as shown in the diagram). The quantity of screws
varies and depends on the size of the unit. Remove the front glass brackets
that holds the glass securely in place
Step 1

Carefully remove the front glass and place it in a safe location.Step 2

Remove the 3 screws ( as shown in the diagram). The quantity of
screws varies and depends on the size of the unit. The canopy light
assembly can now be removed
Step 3

Remove the screws from the defective LED strip and unplug the molex
connector to replace it with a new LED strip
Step 4

Remove the 2 screws and the brackets that hold the left and right sides and
left side glass in place. Safely remove the side glass pieces and take off the
brackets.
Step 1
remove the bracket
remove the side glass Remove the bracket
REPLACING THE FLAME LED LIGHTS
Follow STEPS 1 through 3 from REPLACING THE CANOPY LED:

Using a bracket safely pry up the tray glass. Carefully take off the tray
glass and place it in a safe place.
Step 2

Remove the 5 screws ( as shown in the diagram). The quantity of
screws varies and depends on the size of the unit.
Carefully remove the bracket that holds the back glass
Step 3

Carefully remove the back glass and place it in a safe spot. Step 4

Remove the 8 screws ( as shown in the diagram). The quantity of
screws varies and depends on the size of the unit. The flame effect
steel panel can now be removed
Step 5
the flame effect steel panel

Remove the 3 screws ( as shown in the diagram). The quantity of
screws varies and depends on the size of the unit.
The light barrier can now be removed.
Step 6
light barrier

Removing the flame reflector.Step 7

Step 8 When the flame reflector is removed, the flame LED will be visible.
The LED strips are held in place with screws and are connected to
the other strips by using a molex connector. Unscrew the screws of
the failed LED strip and unplug the molex connector to replace it with
a new one.

REPLACING THE MOTOR
Follow STEPS 1 through 3 from REPLACING THE FLAME LED

Remove the ember bed reflector.Step 1

By removing the two screws circled in red, you will be able to loosen the
motor PCB connector from the fireplace, and then you will be available to
unplug the spade connectors
Step 2

Remove the 6 screws circled in red to take out the failed motor. A new
motor can now be safely installed.
Step 3

Follow STEP 1 from Replacing the motor.
The Tru View – TRV Bespoke series of fireplaces contains 2 LED
strips for the ember bed.
REPLACING THE EMBER BED LED STRIP
The rear set of LED
strips for the ember
bed is situated here
The front set of LED
strips for the ember
is situated here.