Amart Furniture CANTERBURY 66263 User manual

Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
ASSEMBLY INSTRUCTION
CANTERBURY OFFICE CHAIR
ITEM CODE 66263
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
9-1 66263

PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to
the point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
9-2 66263
1
20 Minutes 1 PEOPLE REQUIRED FOR THE
ASSEMBLY
x
1

PARTS LIST
1 HEADREST
2 BACK
3 ARMREST (L)&(R)
4 SEAT
5 GAS LIFT
6 BASE
7 CASTOR
8 MECHANISM
9-3 66263
bolt bolt bolt
bolt Rubber pad Allen key

STEP
1:
Insert
castor to base .
STEP
2:
Put
gas lift into base as instruction shown, then put
gas lift cover on gas lift. Remove gas lift cover before
assembly.
9-4 66263
7 6
5 6
6
6
7
5
gas lift cover
gas lift body

STEP
3:
Put the gasket into the screw B, connect the handrail with
the screw B, connect the rubber pad F, connect it to the
seat , and finally fasten it with an Allen key.
STEP
4:
The metal ring is used to connect the mechanism
.
Connect the mechanism to the back . Twist the screw C
and tighten with the Allen key H.
9-5 66263
3
4
3
4
8
2
8
2

9-6 66263
STEP
5:Connect the mechanism to the seat , and fasten
the screw E to the mechanism with an Allen key.
STEP
6:
Connect the screw D to the headrest on the connection back
and fasten it with an Allen key. Put the whole back and seat
to the gas lift , make sure the mechanism hole directly into
the gas lift . .
8
8
4
4
1
2
1
5
5
4
8
8
5

9-7 66263
STEP 5:
Assembly is complete.

GENERAL PRODUCT CARE
To protect your furniture, we suggest the following:
*Avoid placing your furniture in direct sunlight.
*Do not place furniture directly under windows.
*Do not place sharp materials (knife, fork, etc.) directly
onto your furniture as sharp material may scrape and
damage the finish.
*Do not place material with high temperature directly onto
the surface of your furniture.
*Clean up spills quickly. Water left over a prolonged period
of time may cause damage. Alcohol, perfume, nail polishes,
aftershave and some medication may cause severe finish
damage if not cleaned immediately.
*Use a clean, soft, dry, lint free absorbent cloth to clean
your furniture. Do not use any detergent as they may
contain ingredients that may react and damage the finish.
NOTE: If the above care advise is not adhered to your
product warranty may become void
9-9 66263