American Standard ACTICLEAN 7381737-400.0070A User manual

ACTICLEAN™
---------------------------------------------------------------- 1----------------------------------------------------------------
Product names listed herein are trademarks of AS America Inc. 7302225-100 (06/16)
© AS America Inc. 2014
FLAPPER ASSEMBLY WITH TEETER BAR
P/N: 7381737-400.0070A
• Flapper assembly including adjustable teeter
bar with clevis & hairpins
TO REMOVE FLAPPER ASSEMBLY:
• Turn off water supply; flush toilet (remove all
water from the tank)
• Remove electronic tank top unit by lifting lid
and turning quarter turn screws to the Unlock
position and lifting upwards (see FIGURE 1)
• Remove hair pin and clevis pin from the RED
trip lever arm (see FIGURE 2); this frees the
yoke from the red arm
• Remove hair pin and clevis pin from the
BLACK trip lever arm (see FIGURE 2); this
frees the bead chain from the black arm
• Place fingers underneath hinge and pull up
to release all 4 hinges (see FIGURE 3)
• Remove original flapper assembly fromtank
TO RE-INSTALL:
• Align the flappers to the flush valve body and
push all four hinges into place (NOTE: the
bead chain should face the front of the tank)
• Insert the RED trip lever arm into the yoke
(see FIGURE 2)
• Push the clevis pin through the arm (see
FIGURE 2); make sure the head of the pin is
facing the front of the tank
• Insert the hair pin (see FIGURE 2)
• Attach the BLACK trip lever arm to the bead
chain coupler (see FIGURE 2)
• Push the clevis pin through the arm (see
FIGURE 2); make sure the head of the pin is
facing the front of the tank
• Insert the hair pin (see FIGURE 2)
FIGURE 1
FIGURE 2
FIGURE 3

ACTICLEAN™
---------------------------------------------------------------- 2----------------------------------------------------------------
Product names listed herein are trademarks of AS America Inc. 7302225-100 (06/16)
© AS America Inc. 2014
FLAPPER ASSEMBLY WITH TEETER BAR
P/N: 7381737-400.0070A
COMPLETE BY ADJUSTING THE SETTINGS:
• Depress trip lever handle all the way (A).
• Adjust screw on the teeter bar (B) so rear frame(C) touches the frame stop (D).
• Return trip lever handle (A) to rest position.
• Make sure hook (E) is fully engaged under tab on valve body(F), if not, slightly adjust screw to
make sure hook isengaged.
• Turn water supply on; adjust water level to specified dimension on tank liner sticker and flush
5 times toprime.