American Time Wi-Fi Battery Analog Clock Instruction Manual

Wi-Fi Battery Analog Clocks Quick Start Installation Guide
2
1
Pre-Installation
1. Verify Dynamic Host Conguration Protocol (DHCP) settings.
2. Verify rewall port 123 is open for UDP data transfer.
• Contact your IT staff to verify these settings
3. Plan Analog Wi-FI Clock locations.
4. Verify the intended clock locations have good Wi-Fi coverage.
• Contact your IT staff for signal levels in your facility
Unpack the box
• Remove the components from the box. Save the packing materials in case you need
them later.
Check the contents
Your package contains:
• Analog Wi-Fi clock(s)
• Quick Start Guide
• Installation and Operation Manual
3
Please read this first!
If this is your rst installation or you have questions at any time during this process, please call
American Time toll free at 800-328-8996.
phone: [phone] online: american-time.com fax: [phone]
mail: 140 3rd St. So.; PO Box 707, Dassel, MN 55325-0707

If clock was not precongured at American Time as recommended, please reference the
Installation & Operation Manual.
5
Set up the Wi-Fi clock
1. Apply power to the clock by inserting the barrel plug (B) of the battery pack into the left
side of the Wi-Fi module where the power connection is located.
• Verify the LED (C):
– Flashes red when power is applied to the clock
– Turns solid green within 60 seconds
– Solid orange indicates a time server connection failure
– Solid red indicates a failed Wi-Fi connection
• Verify the clock hands begin to spin rapidly within three minutes after applying power.
• Verify the correct time on the clock within 10 minutes of applying power.
If any of these steps do not occur, reference the Wi-Fi Clock Installation & Operation Manual.
Hang your clocks
1. Place the clock on the wall using the keyhole hanger on the back of the clock or the
optional security bracket (sold separately).
6
B Battery
pack power
input
C LED
A Red gear
locking pin
Security
Bracket
Keyhole
Hanger
INST-WIFI-ANA Rev 3
AC
DC
To
wiring
box
4
Verify clock hand placement
1. Verify the clock hands are set at 12:00 by the factory (if not, stop and call 800-328-8996)
Note: It is normal for the minute hand to shift ± 1⁄2minute.
2. Remove the red gear locking pin (A) from the movement.