AMP Lighting AWL-712IR-BBZ Operating and safety instructions

INSTALLATION & MAINTENANCE GUIDE
Help Hotline:
1-813-978-3900 • Mon-Fri 9am-6pm (EST)
www.amplighting.com
AMP®Low Voltage Landscape Lighting
AMP® ONE HydraProTM Well Light
AWL-712IR-BBZ (Dimmable)

AMP®ONE HydraPro Well Light
AWL-712IR-BBZ (Dimmable)
INSTALLATION & MAINTENANCE GUIDE
www.amplighting.com
–2–
Important Safety Instructions: Read Before Installation
!
This luminaire is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situations.
1. Make sure the power is turned OFF before installing or servicing this
luminaire.
2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M)
or more from pool, spa or fountain.
3. This luminaire is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Wiring connections must be made with UL listed wire connectors that are
suitable for outdoor use.
5. Position the low voltage wire and wire connector so that it is located
within 6 inches (15.2 cm) from a building structure, a luminaire or
tting.
6. The main low voltage cable is intended for shallow burial - less than 6
inches (152 mm).
Important Safety Instructions
!
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
Lighted lamp is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
1. Turn off/unplug and allow to cool before replacing lamp.
2. Lamp gets HOT quickly! Contact only switch/plug when turning on.
3. Do not touch the hot lens, guard or enclosure.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.
6. Do not operate the luminaire tting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS

[email protected] • 813.978.3900
Product Dimensions
–3–
1
Package Contents
Dig Hole
A. (1) Fixture
B. (1) PVC Tube
Parts Required (sold separately)
A. AMP®ONE Design-Master Remote ControlTM
8.25”
6.25”
5.5”
3”3”
3”
Dig a hole in the ground. Make sure
there is approximately 3 inches
surrounding the PVC Tube for pea gravel
or sand on all sides.
PVC Tube
Hole
Soil

INSTALLATION & MAINTENANCE GUIDE
–4–
www.amplighting.com
–4–
3
2
AMP®ONE HydraPro Well Light
AWL-712IR-BBZ (Dimmable)
Wire Connection
Fill Pea Gravel or Sand
Place the xture into the PVC Tube and
pass the luminaire pigtail through the
PVC Tube.
Strip both leads from the luminaire
pigtail. Using two wire connectors (sold
separately), connect the leads from
the luminaire to the main supply cable
leads.
PVC Tube
Wire Connector
Main Supply Wire
Soil
Pigtail
Fixture
PVC Tube
with Fixture
Pea Gravel
or Sand
Install the PVC Tube with the xture
in the hole and ll around the xture
securing it in place with pea gravel or
sand to allow for water drainage.

[email protected] • 813.978.3900
–5–
INSTALLATION & MAINTENANCE GUIDE
AMP®ONE HydraPro Well Light
AWL-712IR-BBZ (Dimmable)

INSTALLATION & MAINTENANCE GUIDE
–6–
www.amplighting.com
–6–
AMP®ONE HydraPro Well Light
AWL-712IR-BBZ (Dimmable)

–6––6–
[email protected] • 813.978.3900
–7–

IS-AWL-712IR-BBZ-ver1.pdf
Specications and product details subject to change without notice.
© Copyright 2019, AMP®Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3900
Help Hotline:
1-813-978-3900 • Mon-Fri 9am-6pm (EST)
www.amplighting.com