AMP Lighting AFL-401-LI-A-BZ Series Operating and safety instructions

INSTALLATION & MAINTENANCE GUIDE
Help Hotline:
1-813-978-3900 • Mon-Fri 9am-6pm (EST)
www.amplighting.com
AMP®Line Voltage Landscape Lighting
AMP® 120V RGBW LED Flood Light (Dimmable)
AFL-401X-LI-A-BZ

AMP®120V RGBW LED Flood Light (Dimmable)
AFL-401X-LI-A-BZ
INSTALLATION & MAINTENANCE GUIDE
www.amplighting.com
–2–
Important Safety Instructions: Read Before Installation
!
This luminaire is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situations.
1. Make sure the power is turned OFF before installing or servicing this
luminaire.
2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M)
or more from pool, spa or fountain.
3. This luminaire is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Wiring connections must be made with UL listed wire connectors that are
suitable for outdoor use.
5. Position the low voltage wire and wire connector so that it is located
within 6 inches (15.2 cm) from a building structure, a luminaire or
tting.
6. The main low voltage cable is intended for shallow burial - less than 6
inches (152 mm).
Important Safety Instructions
!
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
Lighted lamp is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
1. Turn off/unplug and allow to cool before replacing lamp.
2. Lamp gets HOT quickly! Contact only switch/plug when turning on.
3. Do not touch the hot lens, guard or enclosure.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.
6. Do not operate the luminaire tting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS

[email protected] • 813.978.3900
–3–
Package Contents
A. (1) Fixture
Product Dimensions
Products Model #
Model Input
Voltage Watt Input Current
15W Floodlight 120V 15W 0.22A
30W Floodlight 30W 0.41A
10.5”
7.25”
10.25”
8”
9.25”
5”
5.75”
R0.25”
R0.25”
9”
11.25”
8.25”
8.75”
4”
5”
6”
6.75” 30W Floodlight
15W Floodlight
Ø0.75”
Ø0.75”

INSTALLATION & MAINTENANCE GUIDE
–4–
www.amplighting.com
–4–
2
1
AMP®120V RGBW LED Flood Light (Dimmable)
AFL-401X-LI-A-BZ
Rotate Yoke Mount
Rotate the yoke mount towards
the back of the xture body.
Fixture Body
Yoke Mount
Plug in Fixture
Place the xture on the ground at your desired location. Place the plug in
the outlet.
Fixture Body
Plug
Outlet
Ground
Turn on the power and check if the lighting xture works. If not, please
turn off the power and contact with local electrician.

[email protected] • 813.978.3900
–5–
INSTALLATION & MAINTENANCE GUIDE
1
AMP®120V RGBW LED Flood Light (Dimmable)
AFL-401X-LI-A-BZ
IR Remote
An IR Remote is suitable for this xture. Please refer to the following
instructions for usage and battery replacement.
Remove Plastic Film
CR2025
RELEASE
OPEN
PUSH
Remove the plastic lm from
the IR remote before use.
Backing
Plastic Film
IR Remote
Remove

INSTALLATION & MAINTENANCE GUIDE
–6–
www.amplighting.com
–6–
2
AMP®120V RGBW LED Flood Light (Dimmable)
AFL-401X-LI-A-BZ
IR Remote Functions
21
3
4
5
6
7
1. On/Off
2. Brightness Control
3. 16 color selections
4. Flash
◗Mode 1: Repeats Red, Green, Blue + color cycle for 1 second duration of
each of the seven colors within this mode.
◗Mode 2: Hit ash a second time and this mode slowly blends the same
seven colors from mode one, mixing them together.
5. Strobe
◗Mode 1: Pick any color on the remote, then press strobe and that color
will strobe every second alternating between on and off.
◗Mode 2: Hit strobe a second time and this mode will strobe a blended
white color at the same speed as before.
6. Fade
◗Mode 1: Pick any color on the remote, then press fade and that color
will slowly fade in and out every second.
◗Mode 2: Hit fade a second time and it will fade a blended white color in
and out at the same speed as before.
7. Smooth
◗Mode 1: Repeats a ash cycle of Red, Green, and Blue only.
◗Mode 2: Hit smooth a second time and this mode slowly blends Red,
Green, and Blue only; in and out of each other at the same speed.
NOTE: When using the
remote make sure it is
pointed at the sensor in
the faceplate so it operates
properly.

–6––6–
[email protected] • 813.978.3900
–7–
3
Replace Battery
CR2025
RELEASE
OPEN
PUSH
Push the side of the battery
bracket and carefully remove
it from the IR remote. Replace
the battery and then insert the
battery bracket back into the IR
remote.
Replacement Battery Style:
CR2025 Button Battery
PUSH Battery Bracket
Battery
REMOVE/
INSERT
Backing
IR Remote

IS-AFL-401X-LI-A-BZ-ver1.pdf
Specications and product details subject to change without notice.
© Copyright 2021, AMP®Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3900
Help Hotline:
1-813-978-3900 • Mon-Fri 9am-6pm (EST)
www.amplighting.com