&Tradition LATO LN8 User manual

Congratulations with your new Lato table, designed in 2018 by Luca
Nichetto. We hope you will enjoy using this product and follow
these instructions to ensure correct installation. If you have any questions
or comments, please do not hesitate to contact us by mail on:
[email protected]
CONTENTS
A - Table-top with set screw
B - Column
C - Marble base
D - Washer
E - Lock-washer
F - Screw
G - Allen Key
Please read these instructions carefully and retain them for future reference to ensure
that the product is correctly installed if it should be moved or sold. For your own safety,
please study each step of this instruction manual before you commence installation.
&tradition are not responsible for any faults or damages caused by not following these
instructions correctly. Do not modify this product in any way.
SAFETY PRECAUTIONS
- Dispose of any plastic bags and foam from packaging and do not allow children to
play with it.
- The table is only intended for interior use.
- Handle table tops with care in order not to scratch surface.
CLEANING INSTRUCTIONS
Lato Table is made from powder coated steel and natural marble.
Never use aggressive or abrasive cleaning detergents for any parts of the table, as this
will cause irreparable damage.
Powder coated steel
Clean powder coated steel frame with a soft cloth wrung in a solution of water
and universal cleaning detergent and dry immediately with a soft cloth. Avoid use of
abrasive cleaning products such as steel wool or polish.
Marble
Wipe surface of marble with soft, damp cloth and dry immediately after with a soft cloth.
For more severe cleaning only use a cleaning detergent specically for natural stone.
Follow the instructions on the packaging. Cleaning agents not developed specically for
natural stone may permanently damage the surface of the marble and should never
be used.
LATO LN8 & L N 9
BY
LUCA NICHETTO
2018
USER INSTRUCTIONS
AB
C
F
DEG
ANDTRADITION.COM

STEP 1
Place table top (A) on a soft, at surface.
Screw in the metal column (B) on the table top by hand. Fix rmly together.
Take care of the table top during assembly in order to avoid scratches.
STEP 2
Once the metal column is rmly tightened, use the Allen Key (G) to tighten the set screw
on the table top.
STEP 3
Slide down the marble base (C) carefully onto the metal column.

STEP 4
Once the marble base is placed on the metal column, make sure to place the large washer
(D) rst and afterwards place the lock-washer (E), before tightening the screw (F) with the
Allen Key.
STEP 5
Once the bottom screw is tightened, carefully ip around the assembled table by holding
the column - NOT the table top - and at the same time by supporting the marble base.