&Tradition Column JA2 User manual

Congratulations with your new Column shelf, designed
in 2019 by John Astbury. We hope you will enjoy
using this product and follow these instructions to
ensure correct installation. If you have any questions
or comments, please do not hesitate to contact us by
mail on:
in[email protected]
Column JA2
John Astbury
2019
Instructions

Please read these instructions carefully and retain them
for future reference to ensure that the product is used
correctly. For your own safety, please study each step of
this instruction manual first. &Tradition is not responsible
for any faults or damages caused by not following these in-
structions correctly. Do not modify this product in any way.
Contents
AShelf
BColumns ×2
CScrews
×4
DScrews
×4
EPlugs
×4
Tools needed
- Spirit level
- Pencil
- Electric drill
- Screwdriver
Safety precautions
- Dispose of any plastic bags and foam from packaging and
do not allow children to play with it.
- The product is only intended for interior use.
- Handle the product with care in order not to scratch the
surface.
- Spilled liquids of any kind should be removed immediately
as it may penetrate the surface treatment and cause
damage to it.
Cleaning instructions
The product is made of aluminium and lacquered solid
walnut.
- Never use aggressive or abrasive cleaning detergents
for any parts of the shelf, as this will cause irreparable
damage.
- Clean the shelf and the columns with a soft cloth wrung
in a solution of water and universal cleaning detergent
and dry immediately with a soft cloth. Avoid use of
abrasive cleaning products such as steel wool or polish.
Step 1
Carefully place the shelf on a soft flat surface. Place the
two columns as illustrated and align the holes in the shelf
with the holes in the columns.
Step 2
Screw in the 4 screws with a flatheaded screwdriver and
tighten slightly.
Step 3
Using a spirit level, mark the placement of the 4 back side
holes of the column on the wall. Drill holes at the marks
and insert the attached plugs. Please note that the plugs
are universal and recommended for brick and concrete walls.
Column JA2
John Astbury
2019
Maximum load: 10kg
D E
A
CB
5
2
cm
8,5 cm

Step 4
Align the screws with the plugs and mount by fasten the
screws with the screwdriver.
Make sure to keep 2 - 3 mm of space between the wall and
the screwhead.
Step 5
Place the columns on the screws and pull it down
carefully for fastening.
andtradition.com