Anetic Aid QA3 User manual

Quick Start Guide for
This ‘Quick Start Guide’ is designed
to help you use the assist
function in nine simple steps.
However, it is advisable to read the
full ‘Instructions for Use’ thoroughly
before operating the trolley.
Engage the wheel; see section 10
of the ‘Instructions for Use’.
Press the ON/OFF button; a short beep will
sound. Do not touch the handles
immediately after pressing the ON/OFF button.
The ON/OFF light will flash green for 1-3
seconds as calibrates. The ON/OFF
light will turn solid green when calibration
is successful, and a short beep will sound.
is now active.
Disengage the brakes; see section 9
of the ‘Instructions for Use’.
1
2
3
4
continued overleaf...
Innovative medical technology – practically applied

T+44 (0)1943 878647 [email protected] aneticaid.com
Sapper Jordan Rossi Business Park, Otley Road, Baildon BD17 7AX, UK
Driving: Push positively on the
handles and the trolley will begin to move
forwards. Push harder and the trolley will
move more quickly. Pull back on the
handles to slow, stop, or reverse, the trolley.
Driving up a slope: Push the
handles fully forward, and walk at the pace
of the trolley. Pushing harder will result in
unnecessary physical exertion, and the
speed of travel will not be increased.
Driving down a slope: As you approach
a downhill slope, pull back gently on the
handles to decrease the trolley
speed. As you walk down the slope, continue
to pull back gently on the handles to
descend the slope under control.
After 3 minutes of inactivity, the
handles will deactivate; this is indicated by
3 rapid pulses of the ON/OFF light. The
handles are reactivated by a short press
of the ON/OFF button. After 30 minutes of
inactivity, the system will switch off.
If at any stage, one or more of the amber lights
come on, refer to full ‘Instructions for Use’.
5
6
7
8
9
Document number: 992044/1/120220
x 3