Anker eufy Security T8740 User manual

Anker Innovations Limited.All rights reserved. eufy and the eufy logo are trademarks of Anker Innovations
Limited, registered in the United States and other countries.All other trademarks are the property of their
respective owners.
51005002240 V01
USER MANUAL
Video Doorbell Chime

Table of Contents
What’s in the Box 02
What’s Required for Installation? 02
Installation 03
Replacing the Power Connector 03
Notice 05
Customer Service 07

01 English English 02
INSTALLATION
Step 1. Fix the Power Connector to the Doorbell Chime.
A. Place the Power Connector over the Chime in the direction the arrows indicate.
B. Align the raised slots of the Power Connector with the notch on the base of the
Doorbell Chime.
C . Rotate clockwise to lock the Power Connector in place.
Step 2. Plug the Doorbell Chime into an AC power supply at your desired location.
Step 3. Plug the USB dongle into the USB port on the back of the HomeBase 2.
Step 4. In the eufySecurity App, go to Doorbell Settings - Indoor Chime.
Follow the onscreen instruction to add the Chime to your existingVideo Doorbell.
WHAT’S IN THE BOX
Doorbell Chime
Model:T8740
Power Connector
(Pin type may vary
in different regions)
Doorbell Chime USB
Dongle for HomeBase 2
Model:T8741
WHAT’S REQUIRED FOR INSTALLATION?
This Doorbell Chime is an accessory exclusive to the eufy Security Video Doorbell 2K
(Battery-Powered).
The USB dongle enables eufy HomeBase 2 to connect to doorbell chimes. One USB
dongle can control up to 4 doorbell chimes.
The USB dongle can only work with HomeBase 2 when a eufy video doorbell is
connected to this HomeBase 2 and the doorbell is pressed.

03 English English 04
NOTICE
This product complies with the radio interference requirements of the European
Community.
Declaration of Conformity
Hereby,Anker Innovations Limited declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU.For the declaration of
conformity, visit the Web site
https://www.eufylife.com/.
Do not use the Device in the environment at too high or too low temperature, never expose
the Device under strong sunshine or too wet environment.
The suitable temperature for the product and accessories is 0 °C - 45 °C .
RF exposure information:The Maximum Permissible Exposure (MPE) level has been calculated
based on a distance of d=20 cm between the device and the human body.To maintain
compliance with RF exposure requirement, use product that maintain a 20cm distance between
the device and human body.
433MHz Frequency Range:433.92MHZ;433MHz Max Output Power:7.303dBm
The following importer is the responsible party (contact for EU matters only)
Importer:Anker Technology (UK) Ltd
Importer Address: Suite B, Fairgate House, 205 Kings Road,Tyseley, Birmingham, B11 2AA,
United Kingdom
This product is designed and manufactured with high quality materials and components,
which can be recycled and reused.
This symbol means the product must not be discarded as household waste, and
should be delivered to an appropriate collection facility for recycling. Proper disposal
and recycling helps protect natural resources, human health and the environment.
For more information on disposal and recycling of this product, contact your local
municipality, disposal service, or the shop where you bought this product.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Step 5. You may select the ringtone and adjust the volume level by using the Music and
Volume buttons located on the side of the Doorbell Chime.
There are 8 ringtones and 3 volume levels selectable. Each Chime can play a different
ringtone according to your setting.
REPLACING THE POWER CONNECTOR
1. Press the Lock button and twist the Power Connector counterclockwise at the same time to
remove it from the Doorbell Chime base.
2. Install the new Power Connector onto the Doorbell Chime following the same procedure
mentioned at the start of the guide.

05 English English 06
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures: (1) Reorient or relocate
the receiving antenna. (2) Increase the separation between the equipment and receiver. (3)
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. (4) Consult the dealer or an experienced radio/TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements.The device can be
used in xed / mobile exposure condition. The min separation distance is 20cm.
The following importer is the responsible party
Company Name: POWER MOBILE LIFE, LLC
Address: 400 108th Ave NE Ste 400, Bellevue,WA 98004-5541
Telephone: [phone]
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device."
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement."
CUSTOMER SERVICE
• Warranty
12-month Limited Warranty
• Call Us
United States [phone] Mon-Fri 9AM-5PM (PT)
United Kingdom [phone] Mon-Fri 6AM-11AM (GMT)
Germany [phone] Mon-Fri 6:00-11:00
• Email Us
Customer Support: suppor[email protected]
Anker Innovations Limited
Room 1318-19,Hollywood Plaza,610 Nathan Road,Mongkok,Kowloon,Hong Kong
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.