ANSMANN Digicharger Vario User manual

 
D 
F

 
I
H
E
 
 
S
P



 





 

The Digicharger Vario is a universal quick charging unit with
Vmax control technology for rechargeable battery packs
used in digital cameras, camcorders and mobile phones.
Nearly all rechargeable batteries with Li-Ion and Li-Polymer
technology currently on the market, can be charged with the
Digicharger Vario. A microprocessor automatically supervises
the charging process. AA Mignon and AAA Micro rechargeable
cells can also be charged with the Digicharger Vario.
The operation and handling of the batteries with the
Digicharger Vario is very easy.
In order to ensure optimum performance please read the
operating instructions carefully.

> Please read the operating instructions carefully
before using the Digicharger
> Keep the charger in a dry place.
> Never attempt to open the charger by force or use in a
defective condition
> Protect the unit against rains and high humidity
> Not recommended for use by children
> Please only use the AC mains power pack or DC car adapter
that is supplied.
> The Digicharger is only for use with Li-Ion, Li-Polymer and
NIMH technology cells. Do not use with disposable cells or
any other types.
> Remove the Digicharger Vario after charging from
the power source.

Connect the power to the Digicharger Vario using the
supplied AC power pack or DC car cigarette lighter adapter.
The red LED on the top side indicates a ready status.

The Digicharger Vario has 2 exible contact pins, which must
be adjusted for the chosen rechargeable battery pack.
Start by xing the rechargeable battery pack with the
clamping device a little distance away from the contact
pins of the charger. Now slide the contact pins in such a
way that they line up with the contacts of the rechargeable
battery pack.

Next, take out the rechargeable battery pack and clamp
it again, but this time ensure that the contact pins of
the charger and battery pack are touching. The charger
will automatically adjust to the polarity of the pack so
connection can be made either way.
If the battery pack has more than two connections, ensure
that the + and – contacts are chosen.
Once the connecting has been veried by the charger the
green LED will start to ash to indicate that the charging
process has started. After charging is complete the LED stops
ashing and stays on.
If the red LED is ashing the rechargeable pack may be
faulty and need replacing.
For standard round cells please insert the AA Mignon or the
AAA Micro rechargeable cells into the appropriate charging
slots.
Please pay attention to insert with the correct polarity.
The charge will turn o automatically when the cells are full.
If for any reason the cells do not exhibit the right “battery
full” characteristics, the integrated safety timer terminates
the charging procedure after 10 hours.
For an optimum performance we recommend using Li-Ion
rechargeable battery packs and NiMH cells from ANSMANN
Technical details subject to change without prior notice. No
liability accepted for typographical errors or omissions.

Rechargeable batteries are not to be disposed of in domestic
waste. Used batteries should be returned to a battery
recycling collection depot.
Universal fast-charger with Vmax technology for Li-Ion, Li-Po
rechargeable batteries with 3.6 V/3.7 V, 7.2 V - 7.4 and AA
and AAA rechargable batteries.
Charging current: 700 mA

Digicharger Vario
Mains cable 110 - 240 V
12 V car plug
3 years warranty